User's Guide TR-966D 10/100Mbps WDM Fiber Bridge
COPYRIGHT & TRADEMARKS Table of Content Specifications are subject to change without notice. Package Contents........................................................................1 is a registered trademark of TP-LINK Introduction...................................................................................1 Technologies Co., Ltd. Other brands and product names Features........................................................................................
Package Contents The following contents should be found in your box: One WDM Fiber Bridge One AC adapter This User’s Guide Warranty card Introduction The TR-966D product is 10/100Mbps WDM Fiber Bridge. By deploying WDM technology (Wavelength Division Multiplexer), only single-mode fiber is needed to transmit and receive optical Ethernet packets. The TR-966D mediates between a 10/100Base-TX segment and a 100Base-FX segment.
IN K/ AC T IN K/ AC T2 T _L IN K/ AC T2 T _S PD T1 _L IN K/ AC T1 T _S PD _L port. TR-966D _L Auto-negotiation of 10/100Mbps rate and Auto-MDIX for F2 F1 Auto-detection of half/full duplex transfer mode for RJ45 PO W ER 10/100M WDM Fiber Bridge TR-966D Front Panel RJ45 port. Fiber port only support full duplex transfer. 2. Rear Panel Extend fiber distance up to 20km for fiber port.
T1_Link/ Act/ T2_Link/ Act(Green): Steady green Make sure that the length of twisted pair cable (Category- indicates that a valid link exists. Flashing green indicates 5) between 10/100Base-TX device and converter is not that the TR-966D is receiving or transmitting data from the longer than 100 meters. RJ-45 port.
71035589 Appendix Specification Standard Topology Protocol Data Transfer Rate Ports LED indicator General IEEE 802.3 10Base-T IEEE 802.
