Product Manual

READ AND SAVE THESE IMPORTANT INSTRUCTIONS
ASSEMBLY INSTRUCTIONS con’t.
Models CE 30-DS
3. Place rubber insert nuts (Item 4) into round holes on corner gussets located on the backe side of the shutter
(Item 6). It maybe necessary to twist insert nut while pushing or
lightly tap insert nuts into round holes using a
hammer. See figure 5 on reverse side.
4. After installing insert nuts, place shutter face down (gusset side up). Find rubber bushing (Item 8) provided with
hardware kit and place bushing so that they are centered over each rubber insert nut. Then place the fan
assembly (Item 7) on top of the shutter so that the wire mounting hooks of the fan assembly’s guard rest centered
over the rubber bushings and insert nuts. Using a #2 phillips screw driver or equivalent runt the #8-32 x 1/2”
screw (Item 1) and rubberized washer (Item 2) combination down through the centers of the guard mounting hooks,
rubber bushings and into the rubber insert nuts. Securely tighten fastners. Take care to avoid allowing the rubber
insert nuts (Item 4) from being pulled up through the shutter gusset hole before nut has properly expanded. See
figure 8 on reverse side.
INSTALLATION INSTRUCTIONS
Models: CE 10-D Thru CE 30-D and CE 10 DS Thru CE 30-DS and CE 10-DV thru CE 30-DV
1. See previous side for recommended wall holes sizes.
2. Attach fan to installation wall surface as follows for applicable wall structure.
A. Wood structure - use 1/4” lag screws of appropriate length through each mounting hole.
B. Steel Structure - use 1/4” bolt of appropriate length for application, in combination with a 1/4” flat washer and
a 1/4” nut.
C. Masonry Structure - use 1/4” lag screw in combination with a lag shield or equivalent 1/4” masonry fastener of
appropriate length.
3. The above mentioned hardware for mounting fans to wall surfaces is not provided by the manufacturer, since each
mounting application is different. However these items can be obtained from your local hardware store.
4. If shutter is attached be sure when mounted that the shutter blades will open upward.
Note:
This unit is equipped with a speed selector switch, which allows you to select a desired amount of air delivery.
The motor is equipped with a thermo-protector and will automactically de-energize the fan if it were to over heat
for any reason. If this should happen immediately disconnect unit from the power source.
CLEANING / MAINTENANCE INSTRUCTIONS
All maintenance should be done by either TPI Corporation or a qualified electrician. The motor bearings are lubricated
at the factory and should not require any additional lubrication. However, if bearings lubrication is required apply a
small amount of a high temperature bearing grease.
Use an air hose or vacuum to remove any air born contaminates which may have settled on motor or bearings. Use
mild detergent to clean blade and guards. Avoid allowing the cleanser to come in contact with the motor bearings or
windings. Allow fan to completely dry before next use.
Reference parts list on reverse side of this instruction sheet. Save these important instructions. Your TPI Air Circulator
carries a one year warranty.
For additional information on TPI Products or replacement parts, call TPI Customer Service Department at
1-800-251-0382 or write the address below.
P.O. Box 4973 * Johnson City, Tennessee 37602-4973 * 423-477-4131 * Fax [phone]
Form: 9909
ECO 1-5375