User Manual
7 of 7REV 11/15/18 ECO 1-7483 FORM: 9688
RECESSED CEILING PANELS
The recessed ceiling panels are designed to be used with a recessed frame (included with recessed panels)
designed to t the cutout in the ceiling. Ref. Fig. 2. The cutout dimensions are as given in the specication table
for the specic panel model in column D and E. Ref. Fig. 3. The frame must be secured to the framing members
as shown in Fig. 4 using wood screws or nails.
The panel is to be placed through the frame opening and lowered into the frame and wired in accordance with
the N.E.C./C.E.C. and local codes.
WARNING: Adhere to all applicable building codes and requlations when installing or using ceiling
heaters. Failure to do so could cause improper activation of re suppression systems leading to property
damage or bodily injury.
If the junction box is mounted in the ceiling or allowed to be mounted above the upper surface of the ceiling and
below the insulation, 75
o
C conductors must be used. If the junction box is mounted above the ceiling insulation,
the supply conductors may be rated for 60
o
C.
Assemble surface mounting frame as shown below using the screws provided. Ref. Fig. 5. Secure the frame
to the ceiling with appropriate hardware. Locate the frame so that the junction box will be covered when the
ceiling panel is installed. Ref. Fig. 6. Remove one end of the frame, insert the ceiling panel and make electrical
connections. Install the end of the frame.
If the junction box is mounted in the ceiling or allowed to be mounted above the upper surface of the ceiling and
below the insulation, 75
o
C conductors must be used.
If the junction box is mounted above the ceiling insulation, the supply conductors may be rated for 60
o
C.
E
D
"T" BAR
CEILING JOIST
RADIANT-PANEL
POWER
SOURCE
THERMOSTAT
FIG. 2
RECESS
MOUNTING FRAME
JUNCTION BOX
FIG. 4
FIG. 3
FRAME
FIG. 5 FIG. 6
JUNCTION
BOX