User Manual

5 of 7REV 11/15/18 ECO 1-7483 FORM: 9688
RECESSED PANEL FRAME ACCESSORY
FOR USE WITH RECESSED PANELS ONLY
NOMINAL SIZE
22” X 22” (559MM X 559MM)
22” X 48” (550MM X 1219MM)
SURFACE MOUNTED FRAME ACCESSORY
FOR SURFACE MOUNTED PANELS
CATALOG NUMBERS NOMINAL SIZE
SF200 24” X 24” (610MM X 610MM)
SF400 24” X 48” (610MM X 1219MM)
Frame is constructed of extruded aluminum.
INSTALLATION INSTRUCTIONS
T-BAR CEILING PANELS
All wiring must be in accordance with the latest edition of the N.E.C./C.E.C. and local codes. Install the junction
box above and away from the panel above any ceiling insulation. Reference Fig. 1.
WARNING: Adhere to all applicable building codes and regulations when installing or using ceiling
heaters. Failure to do so could cause improper activation of re suppression systems leading to property
damage or bodily injury.
AVERTISSEMENT: respecter tous les codes et réglementations applicables lors de l’installation ou de
l’utilisation de radiateurs de plafond. L’omission de le faire pourrait entraîner une mauvaise activation
des systèmes de suppression des incendies entraînant des dommages matériels ou corporels.
Use supply conductors suitable for 75
O
C.
Heater junction box and thermostat outlet box must be grounded through the grounding conductor. Install
heating panels in “T” Bar ceiling maintaining a minimum clearance between overhead ceiling or roof and at back
of panel.for wiring.
FRAME
ON
LY
FOR
RECESSED
H
EATING
PAN
ELS
SUR
FACE
MO
UNTING
FRAME
FOR
"T"
BA
R
HEA
TING
CP
PANE
L
HEA
TING
PAN
EL
WI
TH
SUR
FACE
MOUN
T
FRAME
SUR
FACE
M
OUN
TING
FRAME
FRAME DEPTH = 3"
CLIP
HEATING
PANEL
"T" BAR
FIG. 1
JUNCTION BOX
BEND OVER
"T" BAR
"T" BAR
CLIP
POWER SOURCE
THERMOSTAT