User's Manual

PRODUCT DESCRIPTION
The HMS series of TPL power amplifiers are intended for use in base station or repeater applications.
They are high power units and in various configurations cover the frequency range extending form
Low Band VHF to 960 MHz.
An HMS series RF power amplifier is a self contained unit which allows operation, metering, and
remote monitoring of all parameters of an RF power amplifier. Its major components are: enclosure,
front panel, rear panel, power amplifier, power supply, cooling fans,
metering, control, and monitoring circuits. The entire assembly is designed to be installed in a nineteen
inch rack.
For operator convenience views of the front and rear of the amplifier are presented in the illustrations
section of APPENDIX 1.
GENERAL SPECIFICATIONS
MODEL: PA9096-350
FREQUENCY RANGE: 920-940 MHz
POWER INPUT: 100 mW – 50 W (model dependent)
NOMINAL POWER OUTPUT: 350 watts
EIA DUTY CYCLE: 100% / Continuous.
MODULATION MODE: FM.
IN/OUT RF CONNECTORS: Type “N” – IN; 7/16 DIN - OUT
OPERATING
TEMPERATURE RANGE: -20º to +50º Celsius.
OPERATING VOLTAGE: 110 VAC Standard, 220 VAC Optional.
HARMONICS and SPURIOUS
EMISSION ATTENUATION: Meets or exceed FCC type acceptance requirements.
CIRCUIT PROTECTION: Provided by the circuit breaker.
REMOTE MONITORING: A DB-25 connector for remote access to metering and indicators is a
standard feature on all HMS RF amplifiers (See Table 1).
OPERATING HUMIDITY: 0%-85% RH (Non-condensing).
STORAGE HUMIDITY: 0% -95% RH (Non-condensing).
Page 2