Installation Guide

Title:
Access Management
Keypad Installation Guide
PN:
xxxxxx
Page:
7 of 14
Author:
Christopher R. Boltë
VER:
2.4
Date:
May, 2019
Access Management Keypad
Installation Guide
b. What is Not Included in the Kit:
The following are supplies that are not provided in this kit which you will need to use during the
installation of the Access Control Keypad:
 Cable Tie’s
 2 x #8 Hex Machine screws
 Length to be determined based on mounting surface thickness + ½ in.
 2 x #8 Nylon lock nuts
 3/8 in. Dia. Split Loom, 3 feet
**Please be sure to meet your company’s Standard Safety Protocols for Installations**
4. Considerations before Installation
The ideal way to ensure a trouble-free installation is to consider your options and make some
decisions before starting the install. Take a good look at the asset (machine or equipment) to
determine how to best install the Access Control Keypad.
Some factors to consider when planning the installation are:
 Mounting Considerations for the keypad are:
o Should not be mounted close to radiating heat
o Should be mounted in spaces where it will not be exposed to undue damage
o Should be mounted in an area where it does not interfere with regular operations of
the equipment/asset or the operator
o Should be mounted in close proximity to the M7 based on the length limits of the
patch cable provided to connect the M7 to the keypad harness
 Keypad harness itself is 3 feet long
o Should be mounted on a flat surface such that the keypad is on a slight angle
 Copy and Record the ESN # (Serial Number) from the label on the keypad for reference.
(see Figure 1)