Use and Care Manual

VER.032818
© TR Industrial
5
10. Mop the oors well with detergent once the job is complete.
11. Keep a double plastic bag handy to place paint chips and
debris into. Dispose of it properly.
12. Remove your protective clothing in the work area after work
is done to avoid bringing it into other environments.
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed
to lter out microscopic particles.
Avoid prolonged contact with dust from power sanding, sawing,
grinding, drilling, and other construction activities. Wear
protective clothing and wash areas with soap and water. Allowing
dust to get into your mouth, eyes or lay on the skin may promote
absorption of harmful chemicals.
ALWAYSWEARCERTIFIEDSAFETYEQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3. 19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection
SAVE THESE INSTRUCTIONS. These instructions will likely come in
handy at some point in the future, and it is recommended that you
refer to them often to keep the information in mind.
WARNING:
Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Leadfromlead-basedpaints.
• Crystallinesilicafrombricksandcementandother
masonryproducts.
• Arsenicandchromiumfromchemically-treatedlumber.
WARNING:
Use of this tool can generate and/or
disperse dust, which may cause serious and permanent
respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure.
Direct particles away from face and body.
WARNING:
ALWAYS use safety glasses. Everyday eye
glasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty.
SYMBOLS
Read the user’s manual in its entirety before using this tool.
Always wear safety goggles.
Always use hearing protection.
.......................................................................................................Volts
..................................................................................................Hertz
........................................................................................ Minutes
...................................................................... Direct current
.................................................................... Class II construction
.......................................................................Safety alert symbol
................................................................................................Amperes
................................................................................................... Watts
.........................................................................Alternating current
...................................................................................No load speed
.......................................................................... Earthing terminal
....................... Revolutions or reciprocations per minute