Trace Elliot® Elf Combo Bass Instrument Amplifiers Owner’s Manual
FCC Compliancy Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, that may cause undesired operation. Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the user’s authority to use the equipment.
ENGLISH TRACE ELLIOT AMPLIFICATION Congratulations on your purchase of a Trace Elliot product. Our experience in design and quality of manufacturing will ensure that you will be able to rely on this product to deliver the solid professional sound you deserve, whether in the studio or on stage.
1 INPUT 2 GAIN 3 4 S BASS MID 5 TREBLE P 6 VOLUME 7 ELF / LINE OUT (1) INPUT socket This is to connect the 1/4” jack lead from your instrument. Alternatively, if any effect units are being used before the amplifier then the output from the last unit is connected here. Experience has shown us that not all 1/4” jack plugs are made equal, therefore, we recommend the use of only high quality 1/4” jack leads for best sonic performance and reliable connection.
Attention: Ne bloquez pas la ventilation 1x8 COMBO Rear Panel 10 220-240 VAC 100-120 VAC 50/60HZ 30 WATTS CONSUMO DE ENERGIA 30WH 8 --Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord. (For Denmark Only) --Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan. (For Finland Only) --Apparatet må tilkoples jordet stikkontakt. (For Norway Only) --Apparaten skall anslutas till jordat uttag.
(13) DI GROUND LIFT switch Pressing this switch in will disconnect the ground connection from pin 1 on the DI output XLR socket(s). Usually this should be left in the out position however there may be certain situations when connecting from the DI socket(s) to another device that a hum is produced due to a ground loop. If this happens then pressing the GND LIFT switch in should eliminate the problem.
Specifications Mains Voltage: 100-120 vac - 50/60Hz - T3.15AL/250V 230 vac - 50/60Hz - T1.6AL/250V Power Consumption: Typical = 30W Maximum = 240W SMPS: Thermal protection Over-current protection Power Amplifier: Protection: Clip limiting Thermal Over-current / Short-circuit DC output Minimum Load: 4Ω example-1 - 4 Ω cabinet / 2 - 8 Ω cabinets noise floor = -104.3dBu noise floor w/sig (nom.) = -88dBu Weight: (1x8) 18.7 lb (8.5 Kg) (1x10) 18.5 lb (8.4 Kg) (1x12) 31.4 lb (14.5 Kg) (1x12 Ext.) 28.1 lb (12.
Features and specifications are subject to change without notice. Trace Elliot • Hwy. 5022 Hwy. 493 North • Meridian, MS 39305 Tel: (601) 486-2255 • Fax: (601) 486-1156 • www.traceelliot.us ©2010 Printed in U.S.A.
