User Manual

5
Rear Panel
10
(8) AC POWER INLET
is is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage
is used. (See line voltage marking on unit).
Never break o the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly. To prevent risk of shock or re hazard, always make sure that the amplier and all associated
equipment is properly grounded.
(9) ON-OFF SWITCH
is rocker switch supplies AC power to the amplier when switched to the ON position. e ON position is
with the right side of the switch pushed “in” or nearly ush with the rear panel.
(10) LINE VOLTAGE SELECT SWITCH
is selector switch allows the amplier to be operated at dierent line voltages. Please be sure this switch
is set to the proper voltage for your area before connecting the amplier to a power source or turning the
amplier on for the rst time. NEVER CHANGE THE POSITION OF THIS SWITCH WHILE THE
AMPLIFIER IS TURNED ON.
(11) Speaker/headphone switch
(12) SPEAKER OUTPUT
is ¼” mono jack is provided for connection of an external speaker cabinet. Minimum load impedance is 4
Ohms.
Please note that this a BRIDGED amplier output, meaning the sleeve of the 1/4” jack is driven by an amplier.
Neither the tip nor sleeve of the speaker plug should ever contact ground, or damage could occur! Also, please
use only cabinets built with professional-quality bass guitar musical instrument loudspeakers.
Be aware that the protection circuitry within the ELF will detect overexcursion events caused by inferior
speakers and guitar speakers, which are not meant for bass. e protection circuits will react to these events
by momentarily interrupting the sound. If you experience interruptions, it means the speaker is exceeding
maximum excursion. As an option, reduce the volume. If this happens repeatedly, ultimately you must change
to a professional bass cabinet with adequate suspension and excursion for bass.
SPEAKER
OUTPUT
SELECT
EARTH
LIFT
DIRECT OUT
POWER
CLASS 2 WIRING
8OHM MIN. LOAD / 200W RMS
DESIGNED IN
THE UK and U.S.A.
MADE IN CHINA
A PRODUCT OF TRACE ELLIOT
5022 HWY 493
MERIDIAN, MS 39305 USA
ON
50/60HZ
30 WATTS
220-240 VAC
100-120 VAC
CONSUMO DE ENERGIA 30WH
R
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAUTION: DO NOT BLOCK VENTILATION.
Attention: Ne bloquez pas la ventilation
CAN-ICES-3(B)/NMB-3(B)
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
THIS APPARATUS SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE
AND OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD NOT
BE PLACED ON THIS APPARATUS
CAUTION
AVIS: DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE
DECHARGE ELECTRIQUE, CET APPAREIL NE DOIT PAS ETRE EXPOSE
A LA PLUIE OU A L’HUMIDITE ET AUCUN OBJET REMPLI DE LIQUIDE,
TEL QU’UN VAS, NE DOIT ETRE POSE SUR CELUI-CI
AVIS: RISQUE DE CHOC
ELECTRIQUE-NE PAS OUVRIR
--Apparatets stikprop skal tilsluttes en stikkontakt med jord,
som giver forbindelse til stikproppens jord. (For Denmark Only)
--Laite on liitettävä suojamaadoituskoskettimilla varustettuun
pistorasiaan. (For Finland Only)
--Apparatet må tilkoples jordet stikkontakt. (For Norway Only)
--Apparaten skall anslutas till jordat uttag. (For Sweden Only)
CAUTION: BRIDGED SPEAKER OUTPUT.
SPEAKER NEGATIVE IS LIVE AND
MUST BE ISOLATED FROM CHASSIS.
DO NOT TOUCH ¼” JACK PLUG
WHILE AMPLIFIER IS OPERATING.
PRUDENCE: PRODUCTION DE SPEAKER
CONSTRUITE UN PONT. LE SPEAKER NEGATIF
EST VIVANT ET DOIT SOYEZ ISOLES DES CHASSIS.
NE TOUCHEZ PAS ¼” LA PRISE DE COURANT
DE CRIC PENDANT QUE L’AMPLIFICATEUR OPERA.
1x8 COMBO
8 9 11 12 13 14