Datasheet

http://www.tracopower.com Page 2 of 3
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
DC/DC Converters
TMV Series 1 Watt
Input Specifications
Input current no load /full load 5 Vin models 30 mA / 270 mA typ.
12 Vin models 12 mA / 110 mA typ.
24 Vin models 7 mA / 55 mA typ.
Surge voltage (1 s max.) 5 Vin models 9 V max.
12 Vin models 18 V max.
24 Vin models 30 V max.
Reverse voltage protection 0.3 A max.
Reflected input ripple current can be reduced by ext. 1–3.3 µF polyester film
capacitor
Input filter internal capacitor
Output Specifications
Voltage set accuracy ±1 % typ. / ±3 % max.
Voltage balance (dual output models, balanced loads) ±0.1 % typ. / ±1 % max.
Regulation – Input variation (1 % change of Vin) 1.2 % typ. / 1.5 % max.
– Load variation (20 – 100 %) 5 to 10 % max.
Ripple and noise (20 MHz Bandwidth) 65 mVp-p typ. / 100 mVp-p max.
Temperature coefficient ±0.01 %/K typ. / ±0.02 %/K max.
Short circuit protection limited 0.5 s max.
Capacitive load single output models: 220 µF max.
dual output models: 100 µF max. (each output)
General Specifications
Temperature Ranges – Operating 3.3, 5 & ±5 Vout models: –40°C to +85°C
all other output models: –40°C to +90°C
– Case temperature +95°C max.
– Storage –50°C to +125°C
Derating 3.3, 5 & ±5 Vout models: 4 %/K above 75 °C
all other output models: 4 %/K above 80 °C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F at +25°C, ground benign) >2’000’000 h
Isolation Test Voltage (Input/Output, 60 s) 3‘000 VDC
Insulation System Functional
Isolation Capacitance (Input/Output) 60 pF typ. / 100 pF max.
Isolation Resistance (Input/Output) >10 GOhm
Switching Frequency 70 to 120 kHz (Frequency modulation)
Environmental Compliance – Reach www.tracopower.com/info/reach-declaration.pdf
– RoHS RoHS directive 2011/65/EU