Datasheet

www.tracopower.com Page 2
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Input Specifications
Input current (no load) 12 Vin models 30 mA typ.
24 Vin models 20 mA typ.
48 Vin models 10 mA typ.
Input current (full load) 12 Vin; 3.3 Vout models: 915 mA typ.
12 Vin; 5 & ±5 Vout models: 1080 mA typ.
12 Vin; other output models: 1045 mA typ.
24 Vin; 3.3 Vout models: 435 mA typ.
24 Vin; 5 & ±5 Vout models: 530 mA typ.
24 Vin; other output models: 510 mA typ.
48 Vin; 3.3 Vout models: 215 mA typ.
48 Vin; 5 & ±5 Vout models: 260 mA typ.
48 Vin; other output models: 250 mA typ.
Start-up voltage / 12 Vin models 8.5 VDC / 8 VDC
under voltage shut down 24 Vin models 16.5 VDC / 16 VDC
48 Vin models 32.5 VDC / 32 VDC
Surge voltage 12 Vin models 25 V max.
(1 sec. max.) 24 Vin models 50 V max..
48 Vin models 100 V max.
Reverse voltage protection 1.0 A max.
Conducted noise (input) EN 55022 level A, FCC part 15, level A
Output Specifications
Voltage set accuracy ± 1 %
Regulation – Input variation Vin min. to Vin max. ± 0.3 % max.
– Load variation 10 – 90 %
– single output models ± 0.5 % max.
– dual output models balanced load ± 1 % max.
– dual output models unbalanced load ± 3 % max.
Ripple and noise (20 MHz Bandwidth) 50 mVpk-pk max.
Temperature coefficient ± 0.02 % / K
Output current limitation >110% of Iout max., constant current
Short circuit protection indefinite (automatic recovery)
Capacitive load – single output models 2200 µF max.
– dual output models 470 µF max.
General Specifications
Temperature ranges – Operating – 40 °C ... + 71 °C (no derating)
– Case temperature + 95 °C max.
– Storage – 40 °C ... + 125 °C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217 E) >1 Mio. h @ + 25 °C
Isolation voltage Input/Output 1‘500 VDC
Isolation capacity Input/Output 120 pF typ
Isolation resistance Input/Output (500 VDC) > 1‘000 M Ohm
DC/DC Converter
TEN 10 Series 10 Watt