Datasheet

http://www.tracopower.com Page 3 of 4
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
General Specifications
Temperature ranges – Operating – 40°C to +85°C
– Casing temperature +100°C max.
– Storage –55°C to +105°C
Derating 3.3 / 5.0 VDC models: 2.5 %/K above 60°C
other models: 3.3 %/K above 70°C
Thermal impedance – Natural convection 12°C/W
– Natural convection with heatsink 10°C/W
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F, at +25°C, ground benign) >2.3 Mio h
Isolation Test Voltage (Input/Output, 60s) 1‘600 VDC
Insulation System Functional
Isolation Capacitance (Input/Output) 300 pF max.
Isolation Resistance (Input/Output) >1 G Ohm
Switching frequency single output models: 500 kHz typ. (pulse width modulation)
dual output models: 300 kHz typ. (pulse width modulation)
EMC immunity – Electrostatic discharge ESD EN 61000-4-2 8 kV / 6 kV, criteria B
– RF field susceptibility EN 61000-4-3 10 V/m, criteria A
– Electrical fast transient / burst immunity input EN 61000-4-4 ±2 kV, criteria B
– Surge immunity EN 61000-4-5 ±1 kV, criteria B
– Immunity to conducted RF disturbances EN 61000-4-6 10 Vrms, criteria A
Vibration acc. MIL-STD-810F
Thermal shock acc. MIL-STD-810F
Safety standards UL 60950-1, EN 60950-1, IEC 60950-1
UL 62368-1
Safety approvals – UL/cUL www.ul.com -> certifications -> File e188913
Environmental compliance – Reach www.tracopower.com/info/reach-declaration.pdf
– RoHS RoHS directive 2011/65/EU
Physical Specifications
Casing material copper, nickel plated
Baseplate material non conductive FR4
Potting material epoxy (UL 94V-0 rated)
Weight 27 g (09.5oz)
Soldering temperature max. +265°C / 10 sec.
DC/DC Converters
TEN 15 Series 15 Watt
Supporting documents : www.tracopower.com/overview/ten15