Datasheet

http://www.tracopower.com Page 2 of 3
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Input Specifications
Input current no load / full load 5 Vin models: 50 mA / 1460 mA typ.
12 Vin models: 20 mA / 590 mA typ.
24 Vin models: 5 mA / 290 mA typ.
48 Vin models: 3 mA / 145 mA typ.
Start-up voltage / 5 Vin models: 4.4 VDC / 4.0 VDC
under voltage shut down 12 Vin models: 8.0 VDC / 8.0 VDC
24 Vin models: 16.0 VDC / 16.0 VDC
48 Vin models: 32.0 VDC / 32.0 VDC
Surge voltage (1 sec. max.) 5 Vin models: 10 V max.
12 Vin models: 25 V max.
24 Vin models: 50 V max.
48 Vin models: 100 V max.
Reverse voltage protection 1.0 A max.
Conducted noise (input) EN 55022 level A, FCC part 15, level A
Output Specifications
Voltage set accuracy 1.0 %
Regulation – Input variation Vin min. to Vin max. 0.3 % max.
– Load variation 20 – 100 %
single output models: 1.0 % max.
dual output models balanced load: 2.0 % max.
dual output models unbalanced load: 5.0 % max.
Ripple and noise (20 MHz Bandwidth) 50 mVpk-pk max.
Temperature coefficient ±0.02 %/K
Output current limitation >120 % of Iout max., constant current
Short-circuit protection indefinite (automatic recovery)
Capacitive load single output models: 6800 µF max.
dual output models: 1000 µF max. (each output)
General Specifications
Temperature ranges – Operating –40°C to +85°C
– Case temperature +100°C max.
– Storage –55°C to +125°C
Derating 3.5 %/K above 70°C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F, @ +25°C, ground benign) >1 Mio. h
Isolation voltage (60 sec) – Input/Output 1’500 VDC
Isolation capacity – Input/Output 380 pF typ.
Isolation resistance – Input/Output >1‘000 M Ohm (500 VDC)
Switching frequency 300 kHz typ. (Pulse frequency modulation PFM)
Safety standards UL 60950-1, IEC/EN 60950-1
Safety approval CSA File No. 226037
http://directories.csa-international.org
DC/DC Converters
TEN 5 Series 6 Watt