Datasheet

http://www.tracopower.com
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Page 3 of 4
General Specifications
Temperature ranges – Operating –40°C to +75°C
– Case temperature +115° C ma x .
– Storage –55°C to +125°C
Thermal impedance – without heat-sink 6.1°C/W
– with heat-sink 5.1°C/W
Power derating depending on installation!
– without heat-sink 1.5 %/K above +25°C
– with heat-sink 1.5 %/K above +40°C
– with iron base plate (19” x 3.5” x 0.063”) 1.8 %/K above +60°C
please refer to application note for temperature
measure point that should not exceed 115°C.
Over temperature protection at +120°C
Thermal shock MIL-STD-810F
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217F, at +70°C, ground benign) 380‘000 h
Isolation voltage (60sec.) – Input/Output 2’250 VDC (basic insulation)
– Input/Case 1’60 0 VDC
Isolation capacitance – Input/Output 2500 pF max.
Isolation resistance – Input/Output (500 VDC) >1 GOhm min.
Switching frequency 250 kHz typ. (puls width modulation)
Safety standards UL 60950-1, IEC/EN 60950-1
– Certification documents www.tracopower.com/overview/tep160
Remote On/Off – positive logic (standard) – On: 3 to 12 VDC or open circuit
– Off: 0 to 1.2 VDC
or short circuit pin 1 and 3
– negative logic (option) – On: 0 to 1.2 VDC or short circuit pin 1 and 3
– Off: 3 to 12 VDC or open circuit
– Off idle current: 3 mA
Environmental compliance – Reach www.tracopower.com/overview/tep160
– RoHS RoHS directive 2011/65/EU
General Specifications
Casing material metal
Potting material silicone (UL94V-0 rated)
Base material FR4
Vibration MIL-STD-810F
Application note: www.tracopower.com/products/tep160-application.pdf
DC/DC Converters
TEP 160 Series 150 – 196 Watt