Datasheet

http://www.tracopower.com Page 6 of 11
Industrial Power Supplies
TSP-WR Series 180–600 Watt
TSP–BCM24 Battery Controller Module
This module provides a professional battery management system to charge and
monitor an external lead-acid battery. Together with a power supply of the TSP
series, a perfect DC-UPS system can be configured. The connected battery will be
charged and held in charged mode by the power supply. In the event of a mains
power failure the battery will supply the output power until the battery is dischar-
ged. As a consequence, the output voltage of the system is equivalent to the battery
voltage. To avoid overcharging the battery, an external temperature sensor adjusts
the battery voltage automatically to the required end of charge voltage. This can
extend the battery life.
The battery is protected against deep discharge. Mains power and battery status
are monitored regularly and failures indicated by corresponding LED’s and alarm
outputs. The module also provides an external On/Off input to switch-off both,
power supply and battery.
Order code
(includes terminal plugs)
Inputs Input Power
max
Output Voltage
nom.
*Output Power
max.
TSP-BCM24
24 VDC Power Supply
360 W
24 VDC
360 W
TSP-BCM24A
and 24 VDC Battery
600 W
600 W
Models
*reduce max. output current by battery charging current
Function Diagram Connector Positions
Battery Controller
TSP
Temp.
Sensor TSP-TS (included)
Volt adjust
Output
Load
DC-OK
input
+
_
J1.2
J1.1
J3.1
J3.2
J5.1 J5.2
J2.2
J2.1
J2.4
J2.3
+
_
DC IN
Remote
Link
24V Battery
+
_
BAT.-OK
J5.3 J5.4
DC-OK
output
J5.5 J5.6
Remote
On/Off
J5.7 J5.8
T
Fuse
J5.9 J5.10
J1.4
J1.3
Power
Supply
Front view Bottom viewTop view
AC OK
Bat. OK
DC OK
Temp. Sensor
(TS)
DC IN Battery
- + - +
Output
- - + +
Remote Link
Remote On/Off
48 V/6.6 A
Specifications
Operating temperature –25°C to +70°C max.
derating above +40°C 1.5 %/K
Electromagnetic compatibility in correspondence to connected units (no internal
switching device)
Battery protection over voltage, deep discharge, short circuit- and
revers connection (built-in fuse)
Status signals DC-OK input, DC-OK output, BAT OK
all relay contact closed at status OK
Rating per relay contact 30 VDC/1.0 A max.
Dimensions see page 8
Remote link cable (0.5m) 1 cable included (order code TSP-JC)
www.tracopower.com/products/tsp-rc-cable.pdf
Remote On/Off by ext. contact: contact open = On, contact closed = Off
Installation instructions www.tracopower.com/products/tsp-bcm_inst.pdf
TSP-TS battery temperature sensor
(10 kOhm NTC with 2m cable) included