IN-25854 Rev.
CabRac Installation Manual Table 1. Tools Required 1) Socket Wrench 2) 17 mm Socket 3) 5mm Allen Wrench 4) 5/16" Allen Wrench 5) 7/32" Allen Wrench 6) Tape Measure Installation Notes: CabRac mounts onto the side rails of your truck without any drilling Installation should take approximately 50 minutes to complete Recommended 1) Torque Wrench 1. Verify that you have received the correct parts using the following parts list, along with the assembly and packing check list.
LEFT AND RIGHT UPRIGHT ASSEMBLY Figure 1. Figure 2. 1. Using Figure 2 select the correct mounting hole for your truck. Once hole is selected, plug the remaining holes using the plastic ratcheting rivets (item 3). Figure 3. 2. Assemble 3/8"-16 x 3.0" socket head cap screw (item 6) and 3/8" washer (item 10). Insert the assembly through the selected mounting hole for your truck.
CROSSBAR ASSEMBLY Figure 4. 1. Slide four square nuts (item 5) into the bottom T-Slot on the crossbar. Reference Figure 4. 2. Insert a crossbar end cap (item 2) into each end so that the flat edges of the end caps line up with the edge of the crossbar. Reference Figure 4. 3. Secure end caps with M6 x 1 (item 9) socket head cap screw using the 5mm Allen Wrench through the bottom of the crossbar. Reference Figure 4. 4 CabRac INSTRUCTION MANUAL TracRac Inc.
T-SLOT CROSSTUBE INSTALLATION Figure 6. Figure 5. Note: Length on tubes increase from top to bottom. Top tube being the shortest. 1. Insert the shortest tube into the top CabRac bushing onto the assembled upright, making sure that the square nut is located on the inside of the T-Slot. Reference Figures 5 and 6. 2. Repeat for the remaining cross tubes. 3. After all three cross tubes are lightly secured, insert the other assembled upright onto the opposite end of the tubes. TracRac Inc.
CROSSBAR INSTALLATION Figure 7. 1. Measure the inside bed width just behind the cab of your truck and set dimension A to that measurement (Figure 7). 2. Tighten the socket head cap screws located on the bottom of all six bushings using the 7/32" Allen Wrench. Torque to 138 in/lbs. 3. Install cross bar onto saddle plates of the assembled uprights making sure that the four button head cap screws are through the saddle plates. 4.
MOUNTING CABRAC TO THE TRUCK Figure 8. 7 Figure 9. CAUTION: TracRac strongly recommends the following step be completed with the help of another person. 6 1. Lift the assembled CabRac and mount it to the truck bed side walls by inserting the rubber expansion blocks into the stake pockets. Secure rubber block by tightening the 3/8"-16 screw using the 5/16" Allen wrench. Reference Figure 6. Torque to 160 in/lbs. 2.
