Manual

Table Of Contents

CabRac INSTRUCTION MANUAL 3

TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4839 * 800-501-1587

LEFT AND RIGHT UPRIGHT ASSEMBLY

1. Using Figure 2 select the correct mounting hole

for your truck. Once hole is selected, plug the

remaining holes using the plastic ratcheting

rivets (item 3).

2. Assemble 3/8"-16 x 3.0" socket head cap screw

(item 6) and 3/8" washer (item 10). Insert the

assembly through the selected mounting hole

for your truck. On the underside of the upright

base insert the rubber shim*, then the rubber

expansion block, finally thread on the brass

pocket nut (item 8). Reference Figure 3. Note:

The brass pocket nut shall be tightened so that

the rubber block and nut do not rotate freely.

They will be fully tightened later on in the

assembly.

3. Insert 3/8"-16 x .625" button head cap screw

(item 4) into screw hole located on the underside

of the CabRac bushing. At the same time thread

on the stainless steel square nut (item 5) only

so that the button head cap screw does not fall

out. This will be tightened down later on in the

installation. Reference Figure 1.

4. Repeat step 3 for the remaining bushings.

5. Repeat steps 1-4 for the remaining uprights.

* There is a left and right rubber shim. The hole

pattern will match its corresponding upright base.

Figure 3.

Figure 2.

Figure 1.