User's Manual

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help

2.2. No unauthorized modifications

CAUTION: This device may not be modified, altered, or changed in any way without signed written

permission from Tractel®. Unauthorized modification may void the equipment authorization from

the FCC and will void the Tractel® warranty.

2.3. FCC RF Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for general population

(uncontrolled exposure). End users must follow the specific operating instructions for satisfying RF

exposure compliance. This transmitter meets both portable “limb” and mobile limits as demonstrated

in the RF Exposure Analysis. This transmitter must not be co-located or operating in conjunction

with any other antenna or transmitter except with module FCC ID: OVL-RF24GHZ and in

accordance with FCC multi-transmitter product procedures

2.4. IC Information

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject

to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired

operation of the device.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a

type and maximum (or lesser) gain approved for the transmitter by Industry Canada.

To reduce potential radio interference to other users, the antenna type and its gain should be so

chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for

successful communication.

This device complies with Industry Canada radiation exposure limits set forth for an uncontrolled

environment (uncontrolled exposure). End users must follow the specific operating instructions for

satisfying RF exposure compliance. This transmitter meets both portable “limb” and mobile limits as

demonstrated in the RF Exposure Analysis and SAR test report. This transmitter must not be co-

located or operating in conjunction with any other antenna or transmitter except with module IC:

3619A-RF24GHZ.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR

d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement.

Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner

avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par

Industrie Canada.