Installation Guide

CARE & CLEANING: Proper cleaning is necessary to maintain performance and appearance, while also

ensuring safe operation. The frequency of cleaning should be according to the type and amount of cooking. Best

results will be achieved by cleaning soiled components as soon as possible. Filters must be cleaned regularly.

Using the aluminum knob, lightly pull the filter toward the front of the liner while pulling the backside downwards.

Replacing the filter is just as easy as taking it out. For visual instructions on how to remove the filters visit our

YouTube page (https://www.youtube.com/channel/UCwVIbi_9hbuIATTYvz43oBA).

The filters may be cleaned by hand washing in hot water using a mild detergent solution, or by placing them in a

dishwasher. Locate holes on the sides of the filter. Put filter in dishwasher with holes facing up so detergent can

enter filters. Dry the filters completely before using again. Rinse and dry with a soft lint-free cloth. Always wipe

stainless steel surfaces with the grain. Never wipe across the grain. After cleaning, reinstall the filters carefully.

>> Most common scrubber type pads will scratch the hood.

CAUTION:

If a commercially available stainless steel cleaner is used, it is important to read the labels for chlorine compounds.

Chlorine is a corrosive substance, DO NOT USE. Follow polish manufacturer’s instructions.

LED LIGHT BULBS:

Trade-Wind

liners are designed for MR16/GU10 LED flood light bulbs. They can be purchased at most home or

grocery stores. The bulbs provided with the unit are 3.5 watt, 350 lumen, and 3000K (color temperature).

Explaining the Remote

The diagram to the left shows all functions of the

remote. Push the speed or light buttons once to turn

on; push the same button a second time to turn off.

You can use the ―off‖ button to power off the lights

and blower simultaneously.

The ―5 minute delay auto off‖ button can be pressed

when the blower is on at any speed. The blue light

behind the speed button will blink showing that this

feature has been activated. It will continue to blink for

5 minutes and then the blower will shut off

automatically. If you press the ―5 minute delay auto

off‖ button again the blinking on the speed button

stops and the blower has returned to manual mode.

If you would like to mount the remote to any surface near your range, Velcro pieces have been provided. Peel and

stick one piece to back of remote, and the other to desired surface.

If battery in remote needs replacing, use a CR2025 watch battery. These are very common and easy to find. To

access, look to the bottom end of the remote; push release to the right, and slide battery tray out.

Range of Remote Control

The infrared transmitter at the top of the remote must be pointed in the direction of the electronic control at the right

front of your hood or liner. Range distance will vary depending on your installation, but see diagram below for

approximate range area.