Owner Manual

INSTALL EAR ASSEMBLIES TO GRILL FRAME:
Insert the Ear Assembly (9) onto the Grill Frame Assembly aligning it with the pre-
punched holes and secure using 2 each #8 self drilling Screws (14). Repeat the process
with the other ear.
INSTALL DOOR HANDLE TO DOOR:
Insert the 1/4 flat washer (12) onto the 1/4-20 x .375 Bolt (11) and insert into slot in
Door Assembly (2) then thread into the door handle (10). Repeat the process on
the other side. Note do not over tighten the bolts to the handle.
NOTE: If at this point you are ready to start your Grill, refer to the INITIAL FIRING
INSTRUCTIONS in SECTION TWO of this manual or on a separate sheet in the
PELLET HOPPER before proceeding with further assembly.
WARNING!
Many parts of the Grill will become very hot during operation. Care must be taken
to avoid burns, both during operation and afterwards, while the Grill is still hot. It
should never be left unattended when young children are present. Never move
the Grill when it is operating. Let it thoroughly cool before moving or attempting
to transport.