Owner Manual

20
Probe 1
Probe 2
WARNING! Remove all unburned
pellets and ash from inside and
around the repot. (See instructions
for proper handling and disposal of
ash on page 19.)
Plug power cord into an appropriate
grounded electrical outlet and restart
the grill. Pellets should fall into the
repot and the hot rod should begin
to heat (it will start to turn red).
CAUTION! Do not touch the hot rod.
3 4
Probe
Selector
Probe 1
Probe 2
375Smoke
Shut Down
Cycle
High
Power
OFF
ON
DANGER! If the grill failed to light or
the re went out, turn the switch OFF
(O) and disconnect the power cord.
If the grill is still hot, allow it to cool
thoroughly.
Open the door and remove all food,
the porcelain-coated grill grates, the
grease drain pan, and the heat bafe.
WARNING! If at any time the grill fails to light or the re in the repot goes out while cooking or smoking
and there are sufcient pellets in the pellet hopper, it is important to follow these steps. Failure to do so may
cause a hazardous "over-ring" of your grill due to an excess of unburned pellets in the repot.
1
2
REIGNITING YOUR GRILL
66103_PRO15_v10.indd 20 11/12/15 11:30 AM