User Manual

5
3. Install the front track bar relocation bracket (82-
TM20032) into the original track bar mounting
pocket using the OE bolt and supplied spacer
(35-TM30024).
4. Secure the track bar relocation bracket to the
axle mounting pocket using the supplied 5/16” X
1” bolts and hardware.
5. Use the (2) holes in the support leg of the track
bar bracket as a guide to center punch and drill
the mounting holes in the axle upper control arm
mount. Drill the holes using a 5/16” drill bit.
6. Bolt the support leg of the track bar bracket to
the upper control arm mount using the supplied
5/16” X 1” bolts, washers and nut plate (35-
TM20036).
7. Torque the 5/16” hardware to 25 ft./lbs. and the
OE bolt to 125 ft./lbs.
8. With the front axle supported, unbolt the lower
front control arm from the front axle mounts.
9. Using a chisel, remove the alignment plates
from the factory mounts.
10. Reinstall the front lower control arms to the axle
mounts using the supplied alignment plates.
Rotate the plates so that the large lobe is facing
toward the front of the vehicle. Torque to 95 ft./
lbs.
11. Repeat steps 6 through 8 on the remaining side
of the vehicle.
12. Carefully lower the front axle to ease in the new
coil spring installation. Using the factory isola-
tors install the coil springs (TM3340-60020) into
the spring buckets
13. Raise the front axle into place. Make sure the
coil spring seats properly on the lower spring
perch.
14. Install your new front shocks (TM73265005) us-
ing the previously removed OE hardware.
15. Torque the OE shock hardware according to
manufacturers specifications.
16. Reinstall the OE front sway bar end link into
original mounting bracket on the axle using the
previously removed OE hardware. Torque to
manufacturers specifications.
17. 2007-2010 models only: Install the front brake
line brackets (35-TM20010) to the frame and
secure using the provided 5/16” X 1” bolt s and
hardware.
35-TM20041
Alignment
Plate
35-TM20010
Front Brake
Line Drop
OE bolt
5/16” X 1”
bolt
Front
Axle
90-TM10001
Bump Stop
Extension
TM3340-60020
Front Coil
Spring