Instructions / Assembly

9
Operating Instructions
STEP 7: STORING THE DEVICE
1. Remove the drill/drive handle.
2. Lower your trailer’s existing jack until the
Trailer Valet is above the ground.
3. Insert the rotation pin into the jack
assembly.
4. Choose between the following two
options:
Option 1: Remove the 5X
Remove the stow pin and detach the unit
from the mounting bracket. Restore the
clevis/stow and rotation pins. Store the 5X in
a safe place.
Option 2: Keep the 5X Attached to the Trailer
Tongue
Crank the jack handle until the unit jack is
fully withdrawn. Then, remove the cotter
and clevis/stow pin and rotate the unit 90
degrees with the “Trailer Valet” logo facing up.
Restore the clevis/stow and rotation pins
while the unit remains attached to the
mounting bracket. This will allow the 5X to
remain attached to the trailer while being
towed.
The Trailer Valet 5X comes with a security
bolt (part 21) that is an option to secure
the device while trailering. If you travel with
the 5X and choose to use it, the bolt slots
through the back of the mounting bracket
and threads into the tube of the 5X jack.
Failure to lock in the pins
and bolt prior to trailering with the unit in
the stow position may result in the unit
becoming dislodged during movement.