User Manual

ManualsBrandsTrakPower ManualsToolsTK955 Digital Soldering Station

IRON HOLDER

TIP RETAINER NUT

CLEANING SPONGE

CHISEL TIP

TIP RETAINER

CALIBRATION ADJUSTMENT

SECURITY KEY

PENCIL TIP

TEMPERATURE CONTROLS

DIGITAL DISPLAY

RETAINING NUT

CORD

RECEPTACLE

™

For best results read the entire manual before operating.

TK955 Digital

Soldering Station

Packing List

● TK-955 Soldering Station ● Iron Holder with Sponge

● Soldering Iron with Tip ● 2 Security Keys

● Pencil Tip

Precautions

CAUTION: When the power is on, the tip temperature is between 200°C / 400°F and 480° C / 899°F. Since

mishandling may lead to burns or ﬁ re, be sure to comply with the following precautions:

•

Do not touch the metallic parts while operating.

•

Always store the iron in the holder when not in use.

•

Do not use the product near ﬂ ammable items.

•

Advise other people in the work area that the unit can reach a very high temperature and should be considered

potentially dangerous.

•

Turn the power off while taking breaks and when you are ﬁ nished using it.

•

Before replacing parts or storing the unit, turn the power off and allow the unit to cool to room temperature.

To prevent damage to the unit and ensure a safe working environment, be sure to comply with the following precautions:

•

Do not use the unit for applications other than soldering.

•

Do not hit the soldering iron against the work bench or other objects to shake off residual solder.

•

Do not modify the unit.

•

Use only genuine replacement parts.

•

Do not bend or damage the security key. Should the key become bent, do not force it into the station.

•

Do not allow the unit to become wet or use the unit when your hands are wet.

•

The soldering process will produce smoke. Make sure the area is well ventilated.

Summary of content (4 pages)

PAGE 1
™ TK955 Digital Soldering Station DIGITAL DISPLAY IRON HOLDER RETAINING NUT TEMPERATURE CONTROLS CLEANING SPONGE CHISEL TIP SECURITY KEY CORD RECEPTACLE TIP RETAINER TIP RETAINER NUT CALIBRATION ADJUSTMENT PENCIL TIP For best results read the entire manual before operating.
PAGE 2
Setup and Operation 1. Connect the soldering iron cord assembly to the receptacle. Secure it by rotating the retaining clip clock-wise. 2. Install the desired tip. 3. Saturate the cleaning sponge with water and place it into the holder. 4. Plug the power cord into a grounded outlet. 5. Turn the power switch on. The heater LED will flicker when the temperature has stabilized. The heater LED is located in the lower right corner of the display.
PAGE 3
5. To change temperature units: Use the “UP” and “DOWN” buttons to change between 1C (for Celsius) or 1F (for Fahrenheit). 6. When desired unit is displayed, press NOTE: Heater Error Temperature Tolerance: If power is being sent to the the “*” button. The station is now in soldering iron and the tip temperature falls below the heater error temperature heater error temperature tolerance tolerance, the temperature display will flash. This indicates a possible heater setting.
PAGE 4
Replacing the Tip 1. Turn off, unplug, and allow the iron to cool to room temperature. 2. Loosen and remove the retaining nut. 3. Remove the tip holder. RETAINING NUT THREADS TIP HOLDER THREADS TIP 4. Remove and dispose of the old tip. 5. Wipe the threaded section of the iron and the retaining nut with a dry rag. 6. Install the new tip, holder, and retaining nut. The nut should only be tightened to finger tight. 7. Plug in and turn on the iron.