Installation and Maintenance Manual

Maintenance
GAND-SVX01B-EN 33
Figure 22. Power venter assembly
Notes:
1. For item No. 6, use counter-clockwise rotation.
2. DO NOT OVERTIGHTEN CELCON NUT! HAND TIGHTEN ONLY! DO NOT USE TOOLS! Approximate 1/3 turn maximum or 8 inch pounds is sufficient from
the point where the tube does not slip in or out.
3. Flue Sizes:
100/175 units: 4” dia. flue outlet Reducer required—to be supplied by installer.
200/250 units: 5” dia. flue outlet (no adapter required).
300/400 units: 6” dia. flue outlet Increaser required—to be supplied by manufacturer.
Ref. No. Description
1 Blower Housing Assembly
2Speed Nut
3 Motor
4 Washer, Plain
5 Plate Adapter
6 Blower Wheel (see Note 1)
7 Mounting Bracket (Pressure Switch)
8 Mounting Bracket (Junction Box)
9Screw, S.T.
10 Screw, Machine (L = 3/4”)
11 Nut, Keps (Ext. Lock Washer)
12 Air Pressure Switch
13 Drill Screw
14 Junction Box Cover
Ref. No. Description
15 Snap Bushing
16 Relay (Motor)
17 Draftor Stack Assembly
18 Tubing (Aluminum) Formation
19 Male Connector
20 Locknut
21 Hole Plug
22 Pressure Switch Cover
23 Drill Screw
24 Junction Box Base
25 Purge Relay (not shown) - located in Junction Box