Installation and Maintenance Manual

Installation: Mechanical
20 GTND-SVX01B-EN
larger holes are facing the unit heater, create a
sub-assembly by attaching the top panel
(P/N 251-07942-00X) and the bottom panel
(P/N 251-07943-00X) to the left side panel
(P/N 251-07945) and to th
e right side panel
(P/N 251-07947).
Note: Th
e top and bottom panels must be attached so
that the sides with the larger holes are facing
the unit heater; this makes the assembly easier.
Note: For 90-degree nozzle assemblies, repeat Step 8
to create a second sub-assembly.
9. F
or 60- and 90-degree nozzle assemblies: Using the
enclosed #8-18 x 1/2 screws, attach the sub-assembly
created in Step 8 to the 30-degree assemb
ly installed to
the unit (in Step 1 through Step 6 of this procedure).
Attach the corresponding panels (i.e., top panel to top
panel, right side panel to right side panel, etc).
Note: F
or 90-degree nozzle assemblies, install the
second sub-assembly by attaching it to the first
sub-assembly. Attach the corresponding panels
(i.e., top panel to top panel, right side panel to
right side panel, etc).
10. Install the louvers and cone springs.