Programming Guide

36 VAV-SVP01A-EN
VAV Start Up/Check Out Procedure
The building owner or operator may choose to limit tenant access to certain features. This can be
done through configuration. Or, if a sensor is configured to match all control capabilities of the
building automation system, the locking feature can be used to restrict the tenant from making
changes.
Configuration Procedure
To configure settings on the model WDS sensor, follow this procedure in the order presented.
1. Press the configuration button for 3 seconds.
The display will change to configuration mode. When the sensor is in configuration mode, a
wrench symbol appears on the display and the menus are separated by lines, as illustrated
below.
2. Press the center button on the keypad to begin the configuration process.
Figure 18. Configurations
Figure 19. Configuration mode
Configuration button