Brochure

ManualsBrandsTrane ManualsVariable Air Volume ControllerTrane VariTrac Dampers

Zone Occupancy

Sensor

The zone occupancy sensor works with

applications and zones having

intermittent occupancy during the

occupied mode. The sensor transmits a

signal to a building automation system

upon detection of movement in the

coverage area. Movement is detected by

Passive Infrared (PIR) sensing technology

contained within the zone occupancy

sensor. Since the sensor must detect

movement from an occupant, careful

consideration must be taken regarding

sensor placement.

The sensor is compatible with Trane

VAV and VariTrac

controllers. The sensor

provides isolated single-pole, double-

throw (SPDT) relay contact outputs to

signal the VariTrane

or VariTrac ontroller.

The zone occupancy sensor has a multi-

cell, multi-tier lens with a maximum field

of view of 360°. The maximum coverage

area of the sensor is 1200 square feet

with a maximum radius of 22 feet from

the sensor when mounted at 8 feet above

the floor. Please visit

trane.com

or contact

a local Trane representative for

more information.

Figure 1: Zone Occupancy Sensor

VAV-SLB006-EN

Table 1: Sensor Specifications

Power Supply 24 VAC or 24 VDC, ± 10%

Maximum VA Load 0.88 VA @ 24 VAC,

0.72 VA @ 24 VDC

Isolated Relay Rating 1 A @ 24 VAC or 24 VDC

Operating Temperature 32 to 131°F (0 to 55°C)

Storage Temperature -22 to 176°F (-30 to 80°C)

Humidity Range 0 to 95% non-condensing

Effective Coverage Area 1200 sq ft

Effective Coverage Radius 22 feet

Housing Material ABS Plastic

Dimensions 3.56" dia. x 1.9" deep

(90.5 mm x 48.2 mm)

Protrudes 0.36" (9 mm)

from ceiling when

mounted.

Features

 Ceiling Mounted PIR Sensing

 SPDT Isolated Relay Contacts

 0–360° Field of View

 1200 square feet Coverage Area and 22

feet Radius

 Time Delays of 30 seconds, 10, 20, and 30

minutes

 Maximum and Minimum Sensitivity

Summary of content (2 pages)

PAGE 1
Zone Occupancy Sensor Figure 1: Zone Occupancy Sensor The zone occupancy sensor works with applications and zones having intermittent occupancy during the occupied mode.The sensor transmits a signal to a building automation system upon detection of movement in the coverage area. Movement is detected by Passive Infrared (PIR) sensing technology contained within the zone occupancy sensor. Since the sensor must detect movement from an occupant, careful consideration must be taken regarding sensor placement.
PAGE 2
When the height of the sensor is less than 8 feet, the effective range of the sensor will decrease and the sensitivity to smaller motions will increase. Conversely, when height is greater than eight feet, the effective range of the sensor will increase and the sensitivity to smaller motions will decrease. At heights of more than 12–14 feet, the sensitivity of the sensor will be significantly reduced. Placement of the Sensor Careful considerations must be taken when locating the sensor in a zone.