Catalogue

56 WSHP-PRC020D-EN
Accessories
System balancing hose kit
For automatic system balancing of a water source heat pump, the Mesurflo® self-balancing hose
kit provides a constant flow rate over the pressure differential rage of 2 to 80 psid. As system
pressure changes (through further addition of heat pumps, for example) each individual flow
control valve will automatically adjust to the new system conditions. In variable water volume
applications, a self-balancing hose kit can provide continuous balancing because of its ability to
automatically adjust to the varying system conditions.
Note: At low differential pressure the flow area required to achieve higher flow can exceed the
flow area available for the respective series.Therefore, the minimum pressure differential
requirement is increased for the higher flow ranges of each series Mesurflo valve.
Tracer Loop Controller
Trane’sTracer Loop Controller (TLC) is a cost effective way of controlling the WSHP equipment, as
well as the mechanical components of the system. Fluid coolers, boilers, pumps and water-source
heat pump units can be connected and controlled by the loop controller for total system
optimization.TheTracer loop control panel has the ability to lower or raise the water loop
temperature during low energy use hours (typically during the night time hours) to provide a
greater optimization during the time of day where energy consumption may be at it’s greatest.
Using the loop controller as a means of coordinating cooling or heating storage, the building owner
can expect better efficiencies from the WSHP equipment.
Figure 17. Ball valve kit (manual)/MeasurfloVac kit (automatic)
Flex Hose
Mesurmeter w/PT’s
Optional Yball Strainer
w/Blowdown Valve &
Hose Connector
PT
FLOW
Ball Valve
Optional Isolation Valve
2-Position Valve
AUTOMATIC
TEMPERATURE
CONTROL
VALVE
Flex Hose
Optional Yball Strainer
w/Blowdown Valve &
Hose Connector
PT
FLOW
Ball Valve
Optional Isolation Valve
2-Position Valve
2510 Mesurflo w/PT’s
AUTOMATIC
TEMPERATURE
CONTROL
VALVE