Wireless Ethernet Bridge User Manual

Configuration Command Reference Listing
Trango Broadband Wireless — Atlas5010 page 23
Command Reference Listing
The complete comman d set reference is p rovided below. Yo u can also view a complete listing of all CLI commands by
typing help.
Command Syntax Description
antenna [h|v] Set or display antenna setting. H=Horizontal polarity, V=vertical
polarity.
arq [on|off] Enable or disable Auto Retransmit Request (ARQ). With ARQ
enabled, the Atlas system will retransmit packets which are detected
as missing or corrupted. Default setting=ON.
autorateshift [on|off] Enable or disable automatic rate shift feature. With autorateshift
enabled, the radios will automatically renego tiate speed setting to
maximize wireless link integrity. Default setting=OFF.
Notes:
• Radio will start to perform diagnostic speed test
approximately 50 seconds after association.
• Radio will set new speed after finishing speed test.
• Radio will check link quality for increasing speed every 60
seconds.
• Radio will check link quality for decreasing sp eed every 10
seconds.
• Link quality is based on ARQ retransmit statistics and speed
assessment packets.
• Radio’s speed can be changed manually when auto rate shift
is on, however th e speed will no t be sustained.
• If auto rate shift is turned on after asso ciation, the radio will
not perform speed test.
• If auto rate shift is turned off after associated, rad io will not
perform regular link quality assessment.
autoscanmu [on|off] Enable or disable auto scan MU (RU only). Default setting=OFF .
When autoscanmu is turned on, the RU will automatically scan all
channels and polarizations searching for its p eer MU. Once th e RU
detects the MU it will stop scanning and lock onto the ch an nel of the
MU. The autoscan feature is useful in cases where the user changes
the channel at the MU because the RU will automatically search for
the new channel of the MU. Note: auto-scanning may take as long
as 5 minutes.
Notes:
• RU will not perform auto scan during the first 60 sec after
opmode is turned on.
• RU will initiate auto scan cycle after losing sync fo r 10
seconds.
• RU will scan all “available channe ls” and antenna
polarizations.
• After finishing scan cycle, RU will pick the best channel
and antenna by a) has sync and b) has highest packet rssi.
Afterwards RU will change to that channel with max power.
• If no channel is selected after finishing scan cycle, RU will
initiate auto scan cycle again after 10 seconds.