User's Manual

Altum AC 600 User Manual LT-9064 Rev A 17
3.6 Physical Hardware Button
There is a physical button on the radio unit which is
located to the left of the access port through a tiny
hole. Use a paperclip to set the action desired.
Depending on how long the button is pressed, you
can reboot the board or reset it to factory default.
First make sure then power is on. The following table
shows the duration of the button press and the
corresponding action.
Duration of button press
Action
0 - 3 seconds reboot
4 - 30 seconds reset to factory default
more than 30 seconds do nothing
3.7 Backup/Flash Firmware
The System → Backup/Flash Firmware page lets you
perform backup and restore, or flash a new firmware.
3.7.1 Backup/Restore
Download backup: Generate archive: Downloads a
tar archive of the current configuration files.
Note: The backup archive file should be stored
in a safe place because it contains the wireless
password in clear text.
Reset to defaults: Perform reset: Resets the firmware
to its initial state.
Restore backup: Upload archive: Lets you upload a
previously generated backup archive to restore
configuration files.
3.7.2 Flash new firmware
You can upload a new firmware to replace the
currently running firmware.
Keep settings: Retains the current configuration.
Firmware: Shows the current version of the firmware
and allows you to upload a new firmware.
3.8 Reboot
Perform reboot: Reboots the operating system of
your device. This is similar to the power-off and
power-on cycle. The system configuration remains the
same. Any changes that are not applied are lost.