User's Manual

8 LT-9064 Rev A Altum AC 600 User Manual
Chapter 2: Status Tab
After login, when you click on the Status top-level tab,
you can see the second-level tabs of Overview, Routes,
System Log, Realtime Graphs. This is shown in Figure
2.
Notice in the figure that the radio is using the latest
and fastest 11ac wireless standard that supports a
data rate of up to 866.7 Mbit/s over the air, which
translates to over 600 Mbps Layer 2 Ethernet capacity.
2.1 Overview
The Status → Overview page is divided into the
sections Wireless, Associated Stations, System,
Memory, Network, and DHCP Leases.
Uptime: Displays the duration of time since the radio
was last rebooted.
2.1.1 Wireless Radio Mode
The wireless radio frequency band, supported modes,
and current mode are shown in the box on the left e.g.
“5 GHz 802.11ac/an Radio”. The mode can be AP or
CPE and is set based on the Wifi Configuration. For all
models the 5 GHz radio refers to SMA RP connectors.
The “2.4 GHz 802.11bgn Radio” refers to the N
connectors on the unit.
The word AP in the small callout box means that the
radio is operating in the Access Point (AP) mode. If
the callout is CPE, it means that the radio is operating
as customer-premises equipment (CPE) i.e. a station.
The Letter X is shown if the radio is disabled.
2.1.2 Wireless (for AP Mode)
The Wireless section in the Status → Overview page
shows a summary of the wireless parameters. The
following describes the parameters when the device
is in the AP mode.
SSID: Displays the name of the wireless network that
this access point (AP) is offering, the Service Set
Identifier (SSID).
Figure 5: A summary in the Wireless section for a
device operating as an 802.11ac access point.
Figure 4: Wireless Radio Mode
Figure 3: The Status → Overview page.