User's Manual

Configuration
M5580M-FSU page 11
to execute commands from the
#>Set suid 3
AP to this specific SU.
AP ID Informational parameter that
shows to which AP the SU is
Informational Parameter
associated. Please note that
AP ID is not used by the
system for SU authentication.
Opmode Current Opmode of radio.
opmode su [< y>] / off
This sets the radio in Opmode “SU.” Or OFF
Default Opmode Determines the Opmode (“SU”
or “OFF”) of the radio after
reboot/power cycle. When the
parameter is set to “SU,” the
radio will progress into
Opmode “SU” automatically
fter reboot/power cycle.
set defaultopmode <su | off>
Example:
#>set defaultopmode ap
IP
Subnet
Gateway
IP, Subnet, and Gateway
address of radio.
ipconfig [<new ip> <new subnet mask> <new
gateway>]
Example:
#>ipconfig 10.1.1.3 255.0.0.0 10.1.1.1
TFTPD TFTPD status (on or off).
TFTPD should be turned on to
tftpd [<on | off>]
import file into radio (such as
new firmware). Default is off.
TFTPD will revert to off after
reboot/power cycle.
RF TX Power Current transmit power of the
power set <dBm> (Range is 7..21)
SU not including antenna gain.
This is controlled during the
association process.
Channel Scan Sequence Shows the various channels (in
sequence) that the SU will
freq scantable (displays scan table)
scan while searching for an
freq scantable 5 v (sets Scan table to 5 v)
AP.
Active Channel Shows the channel used in the Information Parameter
current association, and
"Associated" or
"Disconnected" depending on
the association status.
Broadcast Packet Filter This software switch (0) sw 0 [<on | off>] (default is on)
enables/disables the blocking
of Ethernet control packets, Example:
except ICMP and ARP, to
#>sw 0 on
reduce the amount of
unnecessary overhead
introduced to the wireless link.
AP Autoscan Software switch (1) is to sw 1 [<on | off>] (default is on)
turn AP autoscan on or off.