User Manual

Getting Started Connections and Power
Trango Broadband Wireless — Access5830 User Manual Rev. H 3.0 page 10
Section 4 Getting Started
This section explains how to power your radios, establish TCP/IP connectivity to the radios, as well as how to access the
HTTP browser and the command line interfaces.
Connections and Power
Connection and powering of the radios is the same for both APs and SUs.
• Connect a Cat-5 (straight through) Ethernet cable (we recommend shielded twisted pair) between the ODU (out
door unit) port of the J-box and the RJ-45 connector on the radio. Note that this cable will carry power-over-
Ethernet (PoE).
• If connecting to a COMPUTER, use a Cross-Over
Ethernet cable from the NET port of the J-box to the
computer’s Ethernet port.
If connecting to a HUB, SWITCH, or ROUTER, use a Straight-Thru
cable.
• Plug the AC adapter into an AC outlet.
Figure 4-1: Wiring Diagram
Both green LEDs on the J-box should be lit, indicating power is present at the J-box as well as the radio.
You are now ready to configure the radio via the Ethernet port.