User Manual

Getting Started Browser Interface
Trango Broadband Wireless — Access5830 User Manual Rev. H 3.0 page 13
Figure 4-4: Web Browser System Information Page
Figure 3-4 shows the System Information
page for an Access Point. Basic system information for a subscriber unit is
similar, and is covered in detail later in this text.
The following describes the primary features and pages of the HTTP Browser interface:
Navigation Column: The blue rectangular column on the left of all pages. The top displays the model number of the
radio to which you are connected. On the bottom of the Navigation Column is the Current Status of the radio, including
its Base ID, AP ID, and current Opmode. In addition, there are the following links:
System Information Page: Shows most of the basic configuration parameters of the radio. It is the first page shown
after login.
Configuration Page: The essential parameters, such as Base ID, channel, and polarization, are set here.
Advanced Setup Page: The advanced RF parameters, such as Transmit Power, are set here.
Site Survey Page: From here, in Opmode “OFF,” the user can conduct a spectrum analysis.
Subscriber Database Page: This is the page that defines which SUs can associate with the AP.
Link Control Page: With this page you can determine which SUs are connected, and how they are performing.
Command Console Page: Runs any console command that is not interactive (i.e. ipconfig). The results are reported
back on the HTTP screen. For a complete list of console commands, type "help" in the entry field.
Logout Link: This will end the current HTTP session with the radio.
Help Page: The Browser Interface features useful Help
pages that explain all listed parameters. To access the help
pages click on the Help link. For a complete description on the use of the Browser Interface, see Appendix A.