User Manual

Basic Configuration via CLI Access Point Basic Settings
Trango Broadband Wireless — Access5830 User Manual Rev. H 3.0 page 27
.
Table 2: Reference Table of Basic AP System Information
AP SYSTEM INFORMATION PARAMETERS AND RELATED COMMANDS
AP Parameter Description Related CLI Command
Device ID MAC Address of AP N/A
Base ID Specifies the cell or cluster to
which the AP belongs. Base ID is
one of three key pieces of
information, along with active
channel, and SUDB information
for the establishment of a link.
set baseid <baseid>
Example:
#>Set baseid 10
AP ID Informational parameter used to
provide a unique number for each
AP. Useful for AP sector
planning. Please note that AP ID
is not used by the system for SU
authentication.
set apid <apid>
Example:
#>Set apid 3
Opmode Current Opmode of radio.
opmode ap [<y>]
This sets radio in Opmode “AP.” To set radio to
Opmode “OFF,” reboot, and access radio via Ethernet
port within the first 30 seconds.
Default Opmode Determines the Opmode (“AP”
or “OFF”) of the radio after
reboot/power cycle. When the
parameter is set to “AP,” the
radio will progress into Opmode
“AP” automatically after
reboot/power cycle.
set defaultopmode <ap | off>
Example:
#>set defaultopmode ap
Opmode Start Determines the amount of time
the radio will remain in Opmode
OFF after reboot before
progressing to the default
Opmode.
set defaultopmode ap <time (sec)>
Example:
#>set defaultopmode ap 60
IP
Subnet
Gateway
IP, Subnet, and Gateway address
of radio.
ipconfig [<new ip> <new subnet mask> <new
gateway>]
Example:
#>ipconfig 10.1.1.2 255.0.0.0 10.1.1.1
TFTPD Status TFTPD status (on or off).
TFTPD should be turned on to
import file into radio (such as
new firmware). Default is off.
TFTPD will revert to Off after
rebooting.
tftpd [<on | off>]
Service Radius User specified estimate of the
distance of the furthest SU the
AP will serve. Based on this
information, the AP will
determine the maximum wait
time for an SU to respond to a
poll before it starts to poll the
next one. Note: This parameter
has no effect on the actual
coverage radius of the radio.
set serviceradius [<ism> <miles>]
Examples:
#>set serviceradius ism 5
MIR Threshold (On or
Off)
Enable/Disable the Maximum
Information Rate (MIR)
Threshold.
set mir <on | off>