User Manual

HTTP Browser Interface HTTP Browser Interface
Trango Broadband Wireless — Access5830 User Manual Rev. H 3.0 page 52
SU Configuration
Note: Some of the parameters below will be unavailable (grayed out) if the radio is in Opmode "SU." Remember to Save and
Activate Settings.
Base ID: User definable base station
ID (1-127). Typically assigned to a
group of APs at a particular cell site.
The Base ID in the AP must match the
Base ID in SU in order for a link to be
established.
AP ID: User definable AP ID (1-
255). This parameter is for
informational purposes only and does
not play a role in the establishment of
a link.
SU ID: This parameter is used to
uniquely identify the SU within a
particular sector. The range is 1-
8190. The SUID, along with its
priority type, SU to SU group (if
active), CIR, MIR, and device ID
must be in the AP's SUDB before a
link with the AP is established. Can
only be changed while in Opmode
"OFF."
IP Address, Subnet Mask and Gateway: The IP Address, Subnet Mask, and Gateway of the radio for configuration and
network management purposes. Since this is a layer-II device, these parameters do not play a role in the establishment of a
wireless link.
Default Opmode: Operation mode of the radio after power cycle or reboot. When the radio enters Opmode "SU," it will be
transmitting. When the radio enters Opmode "OFF," the radio is not transmitting, but can be accessible via the Ethernet port.
The radio can be put into Opmode "OFF" regardless of its default Opmode by accessing the radio via Telnet or HTTP within
the first 30 seconds after power cycle or reboot.
Switches: Checked means active.
Block Broadcast and multicast packets: Block these types of Ethernet packets when active. ARP and DHCP packets will be
passed regardless of this setting.
Auto Scan AP: Will scan all channels and polarization in search of an AP.
TCP/IP Service for AP: Allows TCP/IP access into the SU via the RF link when the SU is in Opmode "SU."
TCP/IP Service for Ethernet port (Opmode “SU”): Allows TCP/IP access into the SU via the Ethernet port when the SU is
in Opmode "SU."
Scan AP Sequence: The set of channels and antenna polarizations the SU will automatically scan while it searches for an AP.
Remarks: A descriptive text field for general use (i.e. the location of the unit). It does not affect system performance.
Save and Activate Settings: Saves to memory any settings that were altered. These settings are then activated. Note: All
changed settings will revert to previous values after reboot/power cycle if Save and Activate is not selected.
Activate Opmode: Activates radio's Opmode to "SU," which means it is transmitting. To turn a radio to Opmode "OFF," see
Default Opmode.
Reboot System: Reboots the system. Make sure all settings have been saved first.