User Manual

HTTP Browser Interface HTTP Browser Interface
Trango Broadband Wireless — Access5830 User Manual Rev. H 3.0 page 53
AP Advanced Setup Page
Note: The Advanced Setup page is divided into three sections: ISM, U-NII, and Channel Table. There is a different range for
parameters in ISM and U-NII bands. Remember to Save and Activate Settings.
RF TX Power: Sets the conducted RF power output of the radio. This does not include antenna gain. A higher number is
more powerful.
RF RX Threshold: Sets the receive threshold of the AP. The AP will not process signals received below this level, so it is very
useful for interference mitigation. For a smaller radius of operation use a higher threshold (-65 is higher than -70).
Target RSSI from SU: Used to adjust the RF power level of the SUs so they all have roughly the same level at the AP. Make
sure that all SUs are power leveled after changing this number (See Link Control page).
Channel Table: Assigns channel numbers to actual frequencies of operation. Default settings allow the largest number of
channels.