Wireless IR Remote Controller Extender MODEL :MIR-500 OWNERS MANUAL
LOCATION OF CONTROLS Transmitter Side Receiver Side DC Power DC Power IR Probe Transmitter and Receiver Front Infrared Remote Control Antenna Remote Control Indicators & IR Transmitter/Receiver Accessory DC 12 V AC 120V Adaptor x2 Infrared Extender X 3 1,1.
CAUTION: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IMPORTANT SAFETY PRECAUTIONS TO PREVENT FIRE OR SHOCK HAZARD, DO NOT SUBMERGE OR EXPOSE THIS PRODUCT TO WATER. TO AVOID ELECTRIC SHOCK, DO NOT OPEN THE UNITS. THE MIR-500 CONTAINS NO USER SERVICEABLE PARTS. DOING SO WILL VOID THE WARRANTY. USE ONLY THE POWER SUPPLY PROVIDED WITH THE MIR-500 DO NOT OVERLOAD WALL OUTLETS OR EXTENSION CORDS. IF YOU ARE EXPERIENCING DIFFICULTY WITH THIS PRODUCT, DO NOT ATTEMPT TO SERVICE IT YOURSELF. PLEASE CALL YOUR VENDOR FOR ASSISTANCE.
APPLICATION DIAGRAM 1. Stereo system with remote control: IR Signal RF Signal MIR-500 Receiver Wire to Extension Speaker Probe Stereo Wall IR Remote Control MIR-500 Transmitter 2.
Installation & Operation Guide Receiver Picture 1 Picture 2 Working with extender probe Power Adaptor Antenna (Using IR ) Make sure the IR probe is affixed toward IR sensor receiving Window with proper position (within 0.5M and working angles +/- 15°). Picture 3 Working without extender probe Keep Vertical Picture 4 Working without extender probe Side View 0.3 6.6 M 7M Working Angle not more than +/15° Not less than 0.
Transmitter Picture 6 Picture 5 Working Angle not more than +/- 15° Antenna Power Adaptor Keep Vertical Remote Control Picture 7 Antenna Distance Not less than 0.
Care and Maintenance Keep the MIR-500 Remote Extender dry. If it gets wet, wipe it dry immediately. Use and store the MIR-500 only in normal temperature environments. Extreme temperature can shorten the life of electronic devices Handle the MIR-500 gently and carefully. Dropping it can damage the circuit board and can cause it to work improperly. Keep the MIR-500 away from dust and dirt, which can cause premature wear of parts. Wipe the MIR-500 with a damp cloth occasionally to keep it looking new.