User's Manual

RF Emissions Information
This equipment has been tested and found to comply with
the limits of a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If the equipment does
cause harmful interference to a radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged try to correct
the interference by one or more of the following measures:
•Reorient or relocate the receiver unit.
•Increase the separation between the equipment and the
receiver.
•Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•Consult a local or experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires
that you stop using your product. Changes or modifications
not expressly approved by Terk may cause interference
and void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC riles.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
LF-DAS
3
System Contents
Your TERK LF-DAS Digital Audio Sender consist of two
units, the Transmitter (TX) and the Receiver (RX) along with
two AC adapters. Also included are three cables. One 3 foot
long 3.5mm stereo to RCA (red and white) cable, one 3 foot
long USB cable and one 3 foot long 3.5mm stereo to 3.5mm
stereo cable.
Transmitter (TX): The transmitter connects to your digital
audio source such as a desktop or laptop computer, iPod or
other MP3 player, portable DVD player, or any other audio
source with a USB, 3.5mm stereo, or RCA audio output jack.
The transmitter will send your audio signal to the Receiver.
The transmitter can operate on 8 different frequency
channels. You can select the channel with the best
reception by simply pressing the channel select button on
the Transmitter.
Receiver (RX): The Receiver connects to the device you wish
to listen your audio on. This could include powered
speakers, the auxiliary input of a radio, boom box, stereo
system, or your favorite headphones. Simply plug the
required cable into the Receiver and your audio device.
4
T6021-LF-DAS-OM 4X5.qxp 2007.1.30 4:25 PM Page C4
To comply with the FCC RF exposure compliance 
requirements, this device and its antenna must not be 
co-located or operating to conjunction with any other 
antenna or transmitter.