User Manual

3
Connection
Step 1: Use HDMI cable to connect the HDMI IN of WTR-3000 Transmitter to a Source device
(Satellite receiver, CATV STB, BD player, PS3, XBox…) , if you want to watch the source
program on the same time , you can use another HDMI cable connected the HDMI OUT to
display (HDTV).
Step 2: Use HDMI cable to connect the HDMI OUT of WTR-3000 receiver to a display device (HDTV,
Projector…)
Step 3: Connect the IR emitter to the WTR-3000 Transmitter. And then place the emitter probe in front
of the source device’s IR receiver .
Cnect the IR receiver to the WTR-3000 Receiver. And then place the receiver probe in front .
(If you do not need the IR extending function, please skip step 3)
Step 4: Connect a DC 5V/1A power adaptor to the Power Jack (MicroUSB) of WTR-3000 Transmitter.
Step 5: Connect another DC 5V/1A power adaptor to the Power Jack (MicroUSB)of WTR-3000
Receiver.
Step 6: Connection Finish. If you can not get image on your display device, please pairing the TX and
RX first.(Press the MODE key of RX box and then press the MODE key of TX box).
Operation
A. Insatllation
1. Make sure your input AC voltage conforms to the adaptor specifications.
2. Only use the power adaptor provided with the WTR-3000. If you use your own
adaptor, make sure the power output is 5V DC, 1A centre positive.
3. With direct line-of-sight, the maximum range of A/V signal transmission can reach up
to about 100 feet, and this distance would be shortened by obstacles or walls
placed between transmitter and receiver. (The optimum indoor range is under 30M)
4. To ensure good infrared remote control operation aim your remote control at the IR
Probe of the WTR-3000 and press the buttons firmly. ( With some remote controls it may
be necessary to press and hold each button for about a second). The working angle of the
IR Probe is +/- 15 degrees.
5. The remote controller has to be used within the distance of ( from remote control
to receiver )not less than 0.3M and no more than 5M (working angle +/- 15 degrees).