User Manual

5
TROUBLE SHOOTING
1. When there is no picture presented, please:
 Make sure the direct connection from source device to sink device can work properly.
 Check if all connectors are connected well; check if all cables can support the transmission speed.
High Speed HDMI cables are recommended.
 Unplug the power cable to restart WTR-3000.
2. When there is no sound:
 Please try to adjust the volume of TV.
 Check cable connection to see if it fits properly.
 Check cable to see if it supports video transmission only (DVI) or it is damaged already.
 HDCP may not match very well at first connection; please unplug the power cable to restart
WTR-3000.
3. When there is no 3D effect, please:
 Make sure 3D function of 3D TV (or 3D DLP Projector) is activated (set to AUTO or 3D ON).
 Make sure 3D function of 3D source device is activated (set to AUTO or 3D ON).
 Make sure power of shutter glasses is on.
 Check the power of WTR-3000.
 If the 3D HDTV requires an active shutter glasses for 3D viewing, please make sure the active
shutter glasses can match with the 3D TV.
 If the 3D HDTV requires a passive shutter glasses for 3D viewing, please make sure the passive
shutter glasses can match with the 3D TV.
4. If the image is unstable, or snowing image shows on screen.
 You might get interference form other wireless device or heavy power consumption house ware
(ex. WiFi Router, Microwave, air conditioner…). Please keep WTR-3000 away from those
sources of interference.
 The wireless transmission distance may be too far or blocked by wall or other object. Please
place WTR-3000 at other location where you can get good signal and video quality.
 Please change the direction of Transmitter and Receiver to get better reception.
5. If the wireless connection fails.
 Please make sure the power of source device which you want to use is turned ON.
 Unplug the power cable to restart WTR-3000.
6. IF the IR extending function is not work.
 Check if the IR emitter is connected to the WTR-3000 Transmitter, and place the emitter probe in
front of the source device’s IR receiver.
 The IR extending function of WTR-3000 can work with 30~60kHz IR remote control system.
Some IR remote control systems use other frequency, or the IR signal pulse is too short that will
not work with IR extending function.
NOTICE
 Manufacturer reserves the right to make changes in the hardware, packaging and any accompanying
documentation without prior written notice.
 The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks
or registered trademarks of HDMI Licensing LLC in the United States and other countries.
 WTR-3000 incorporates HDMI
®
technology.