Printer User Manual
Revision J
.
" 2
" 2" 2
" 2
The POSjet® 1500 is designed to be placed on point-of-sale terminals, counter tops, or any other flat, stable surface
that can support the weight of the printer (about 6 lbs. or 2.7 kg). Be aware that the environmental conditions of the
location where you place the printer will have an effect on the printer’s performance and longevity. The printer will
run its best when stored and operated in an environment that meets the following temperature and humidity
conditions.
Typical Operating Range: 10°C to 40°C / 50°F to 104°F
*Extended Operating Range: 0°C to 45°C / 32°F to 113°F+
Storage: -10°C to 60°C / 14°F to 140°F
Shipping: -40°C to 70°C / -40°F to 158°F
* Exposure to high or low temperatures for periods of greater than 48 hours will lead to significantly reduced
cartridge life. The Typical Operating Range provides full printer reliability. The Extended Operating Range may
degrade the reliability of the printer and life of the cartridge.
7": *
7": *7": *
7": *
Operating: 10% to 90% RH (non-condensing)
Storage: 10% to 90% RH (non-condensing)
Shipping: 5% to 90% RH (non-condensing)
7)*
7)*7)*
7)*
Printer Life 10,000,000 print lines
Mean time between failures: (without cartridge): 28,000 hours
Average cartridge life (Average 16 dots/character): 7.0 million characters
Autocutter option (partial cut): 1 million cuts
Mean time to repair: 15 minutes
Validation Cycles : 1 million cycles
$7;
$7; $7;
$7;
+2$<
+2$<+2$<
+2$<
Supply voltage: 24 Vdc ± 10%
Supply Current: 1.0Amps
2$<
2$<2$<
2$<
Supply Voltage: 100-240 Vac
Frequency: 50/60 Hz
Supply Current: .5 Amps maximum
The POSjet® 1500 Printer is designed to be AC self-powered in domestic and international markets. The printer is
equipped with a detachable universal input power supply that is designed to operate worldwide without modification.
The power supply is a self-contained integrated switching power supply. The internal fuse (F1) located on the power
supply will blow if the supply has an internal fault. The power supply has the following outputs, +5 VDC, +12 VDC,
and +40 VDC, and an alarm signal input. The AC input connector and power switch are located on the back of the
printer.
Earth Ground
+24 Volt Supply
Ground (+24 V dc)