User manual

Installing a Hard Drive︱

The StoreJet 35 Ultra hard drive enclosure only works with 3.5” SATA Hard Disk Drives.

Installing a Hard Drive

If you purchased a Transcend StoreJet 35 Ultra hard drive enclosure that does not have a SATA hard disk

drive already installed, please read this section for installation instructions. If a hard drive is already installed,

you can skip to the “Connecting to a Computer” section.

1. Remove all eight screws from the back and front of the StoreJet 35 Ultra, then remove both the front and

back metal covers.

2. Place 3.5” SATA hard drive (face-up) into the enclosure so that it lays flat, with its SATA connectors

facing the StoreJet 35 Ultra’s circuit board. Assure that the SATA connectors on the hard drive and the

circuit board are aligned properly.

3. Connect the hard drive to the StoreJet 35 Ultra by gently sliding it towards the circuit board’s SATA

connectors. Do NOT connect the hard drive at an angle, which may damage it.