User's Manual

Troubleshooting
1. I can’t see the Wi-Fi SD network on my device.
A: Check that Wi-Fi connectivity is enabled on your device and confirm that you
have deleted the Direct Share image from your camera. Also, please check the
power status of your camera. The Wi-Fi signal cannot be launched when camera
battery level is too low.
2. I can’t connect wirelessly to the Wi-Fi SD network.
A: Turn your camera off, reinsert the Wi-Fi SD card, and then power on the
camera. Please confirm that you have deleted the Direct Share image from your
camera.
3. I forgot the username and password. How do I access Wi-Fi SD settings?
A: Please delete the Restore Defaults image from your camera. The default
username and password are both reset to admin (all lower case). None of the
files stored on the Wi-Fi SD card are deleted when performing this action.
4. Why are there always 3 images in my Wi-Fi SD card? I can’t delete them.
A: The 3 images are pre-loaded into the Wi-Fi SD card and cannot be deleted
permanently. They are used to change the mode of the Wi-Fi SD card.
5. I can’t find the preloaded images in my camera.
A: Please remove and reinsert the Wi-Fi SD card into your camera. If you still
cannot view the images in your camera, please contact our technical support at
www.transcend-info.com/support
.
6. How do I turn off the Wi-Fi SD card?
A: Simply turn off your camera. All Wi-Fi SD card functions will be disabled.
7. How many devices can connect to Wi-Fi SD simultaneously?
A: Up to 3 devices can connect to the Wi-Fi SD card at the same time.
8. Some empty folders exist in the WiFi SD card, can I delete them?
A: There are some empty folders that are generated and used by the Wi-Fi SD
card. These folders are not deleted permanently and will display again each time