User's Manual
Table Of Contents
- User Manual
- Wi-Fi SD
- Introduction
- Package Contents
- Features
- System Requirements
- Installing the Wi-Fi SD App
- Connecting to the Wi-Fi SD Card using iOS and Android Devices
- Connecting to a Smartphone Personal Hotspot
- Using the Wi-Fi SD App on iOS Devices
- Using the Wi-Fi SD App on Android Devices
- Settings
- Connecting to the Wi-Fi SD Card using Other Devices
- Restore Defaults (Return to Original Settings)
- Upgrading Firmware
- Troubleshooting
- Specifications
- Get more help
- Transcend Limited Warranty
FCC Compliance & Advisory Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful interference and
2. this device must accept any interference received, including interference that
may cause undesired operation of the device.
FCC RF Radiation Exposure Statement
This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
Warning: A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It is essential that only the supplied power cord be used.
Use only shielded cables to connect I/O devices to this equipment.