User's Manual
Table Of Contents
- User Manual
- Wi-Fi SD
- Introduction
- Package Contents
- Features
- System Requirements
- Installing the Wi-Fi SD App
- Connecting to the Wi-Fi SD Card using iOS and Android Devices
- Connecting to a Smartphone Personal Hotspot
- Using the Wi-Fi SD App on iOS Devices
- Using the Wi-Fi SD App on Android Devices
- Settings
- Connecting to the Wi-Fi SD Card using Other Devices
- Restore Defaults (Return to Original Settings)
- Upgrading Firmware
- Troubleshooting
- Specifications
- Get more help
- Transcend Limited Warranty
image. Deleting the image will allow the Wi-Fi SD card to connect to the Internet
hotspot that was set up in Direct Mode. (For directions on deleting images from
your camera, please see your camera’s user manual.)
(On your iOS device)
4. On your iOS device, tap Settings, then Wi-Fi.
5. Under Choose a Network… select the SSID of the Internet hotspot you set up in
previously while in Direct Share mode.
(On your Android device)
4. On your Android device, tap System Settings, then Wi-Fi.
5. Under Wi-Fi, select the SSID of the Internet hotspot you set up in previously
while in Direct Share mode
Note: Only one mode can be used at any time. To switch modes, please turn off the
camera and repeat the steps of the desired mode above.
Note: Preloaded images are not deleted permanently and will display again each
time the camera is turned off and back on.