Datasheet

ManualsBrandsTranscend Manualscomputer componentsJM366D643A-60

512MB 184 PIN DDR333 DDR

SDRAM DIMM With 32Mx8 2.5VOLT

Description

The JM366D643A-60 is a 64M x 64bits Double Data Rate

SDRAM high density for DDR333. The JM366D643A-60

consists of 16pcs CMOS 32Mx8 bits Double Data Rate

SDRAMs in 66 pin TSOP-II 400mil packages and a 2048

bits serial EEPROM on a 184-pin printed circuit board.

The JM366D643A-60 is a Dual In-Line Memory Module

and is intended for mounting into 184-pin edge connector

sockets.

Synchronous design allows precise cycle control with the

use of system clock. Data I/O transactions are possible

on both edges of DQS. Range of operation frequencies,

programmable latencies allow the same device to be

useful for a variety of high bandwidth, high performance

memory system applications.

Features

• Power supply: VDD: 2.5V ± 0.2V, VDDQ: 2.5V ±

0.2V

• Max clock Freq: 166MHZ.

• Double-data-rate architecture; two data transfers per

clock cycle

• Differential clock inputs (CK and /CK)

• Burst Mode Operation.

• Auto and Self Refresh.

• Data I/O transactions on both edge of data strobe.

• Edge aligned data output, center aligned data

input.

• Serial Presence Detect (SPD) with serial EEPROM

• SSTL-2 compatible inputs and outputs.

• MRS cycle with address key programs.

CAS Latency (Access from column address): 2.5

Burst Length (2,4,8 )

Data Sequence (Sequential & Interleave)

Placement

PCB: 09-1395

Transcend Information Inc.

Summary of content (11 pages)

PAGE 1
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 Description Placement The JM366D643A-60 is a 64M x 64bits Double Data Rate SDRAM high density for DDR333. The JM366D643A-60 consists of 16pcs CMOS 32Mx8 bits Double Data Rate SDRAMs in 66 pin TSOP-II 400mil packages and a 2048 bits serial EEPROM on a 184-pin printed circuit board. The JM366D643A-60 is a Dual In-Line Memory Module and is intended for mounting into 184-pin edge connector sockets.
PAGE 2
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 Dimensions Pin Identification Symbol Inches Function Side Millimeters A 133.35±0.20 5.250±0.008 A0~A12, BA0, BA1 Address input B 72.39 2.850 DQ0~DQ63 Data Input / Output. C 6.35 0.250000 D 2.20 0.0870 DQS0~DQS7 Data strobe input/output E 31.75±0.20 1.250±0.00800 F 19.80 0.779 CKE0, CKE1 Clock Enable Input. G 4.00 0.157 /CS0, /CS1 Chip Select Input. H 12.00 0.472 I 1.27±0.10 0.050±0.
PAGE 3
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 Pinouts: Pin No 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 Pin Name VREF DQ0 VSS DQ1 DQS0 DQ2 VDD DQ3 NC NC VSS DQ8 DQ9 DQS1 VDDQ CK1 /CK1 VSS DQ10 DQ11 CKE0 VDDQ DQ16 DQ17 DQS2 VSS A9 DQ18 A7 VDDQ DQ19 A5 DQ24 VSS DQ25 DQS3 A4 VDD DQ26 DQ27 A2 VSS A1 NC NC VDD Transcend Information Inc.
PAGE 4
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.
PAGE 5
12MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 ABSOLUTE MAXIMUM RATINGS Parameter Symbol Value Unit Voltage on any pin relative to Vss VIN, VOUT -0.5 ~ 3.6 V Voltage on VDD supply to Vss VDD, VDDQ -1.0 ~ 3.6 V Storage temperature TSTG -55~+150 °C Power dissipation PD 24 W Short circuit current IOS 50 mA Mean time between failure MTBF 50 Years Note: Permanent device damage may occur if ABSOLUTE MAXIMUM RATINGS are exceeded.
PAGE 6
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 DC CHARACTERISTICS (Recommended operating condition unless otherwise noted, TA = 0 to 70°C) Parameter Operating current - One bank Active-Precharge; tRC=tRCmin; tCK= tCK min DQ, DM and DQS inputs changing twice per clock cycle; Address and control inputs changing once per clock cycle Symbol Max.
PAGE 7
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 AC OPERATING CONDITIONS Parameter Symbol Min Input High (Logic 1) Voltage, DQ, DQS and DM signals VIH(AC) VREF + 0.31 Input Low (Logic 0) Voltage, DQ, DQS and DM signals VIL(AC) Input Differential Voltage, CK and /CK inputs VID(AC) Input Crossing Point Voltage, CK and /CK inputs VIX(AC) Max Unit V VREF - 0.31 V 0.7 VDDQ + 0.6 ns 0.5*VDDQ - 0.2 0.5*VDDQ + 0.2 Note: 1. VIH(max)=4.2V.
PAGE 8
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 AC Timming Parameters & Specifications (These AC characteristics were tested on the Component) Parameter Symbol Row cycle time tRC Refresh row cycle time tRFC Row active time tRAS /RAS to /CAS delay tRCD Row active to Row active delay tRP Row active to Row active delay tRRD Write recovery time tWR Last data in to Read command tCDLR Col. Address to Col.
PAGE 9
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 SIMPLIFIED TRUTH TABLE COMMAND Extended Mode Register Set Mode Register Set Auto Refresh Entry Self Refresh Exit Register Register Refresh Bank Active & Row Addr.
PAGE 10
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 Serial Presence Detect Specification Serial Presence Detect Byte No. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36-61 62 Function Described # of Bytes Written into Serial Memory Total # of Bytes of S.P.
PAGE 11
512MB 184 PIN DDR333 DDR SDRAM DIMM With 32Mx8 2.5VOLT JM366D643A-60 63 64-71 72 73-90 91-92 93-94 95-98 99-127 128~255 Checksum for Bytes 0-62 Manufacturers JEDEC ID Manufacturing Location Manufacturers Part Number Revision Code Manufacturing Date Assembly Serial Number Manufacturer Specific Data Unused Storage Locations Transcend Information Inc.