Datasheet

ManualsBrandsTranscend Manualscomputer componentsTS32MLR72V6F

168PIN PC133 Registered DIMM

256MB With 32Mx8 CL3

Description

The TS32MLR72V6F is a 16M x 72 bits Synchronous

Dynamic RAM high-density memory registered DIMM

module. The TS32MLR72V6F consists of 9pcs 16Mx8

bits Synchronous DRAMs, 2pcs drive ICs for input

control signal, 1pc PLL and a 2048 bits serial EEPROM

on a 168-pin printed circuit board. The

TS32MLR72V6F is a Dual In-Line Memory Module and

is intended for mounting into 168-pin edge connector

sockets.

Synchronous design allows precise cycle control with

the use of system clock. I/O transactions are possible

on every clock cycle. Range of operation frequencies,

programmable latencies allow the same device to be

useful for a variety of high bandwidth, high performance

memory system applications.

Features

• Performance Range: PC-133

• Burst Mode Operation.

• Auto and Self Refresh.

• DQM Byte Masking (Read/Write)

• Serial Presence Detect (SPD) with serial EEPROM

• LVTTL compatible inputs and outputs.

• Single 3.3V ± 0.3V power supply.

• MRS cycle with address key programs.

Latency (Access from column address)

Burst Length (1,2,4,8 & Full Page)

Data Sequence (Sequential & Interleave)

• All inputs are sampled at the positive going edge of

the system clock.

Placement

PCB: 09-0875

Transcend Information Inc. 1

Summary of content (11 pages)

PAGE 1
68PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F Description Placement The TS32MLR72V6F is a 16M x 72 bits Synchronous Dynamic RAM high-density memory registered DIMM module. The TS32MLR72V6F consists of 9pcs 16Mx8 bits Synchronous DRAMs, 2pcs drive ICs for input control signal, 1pc PLL and a 2048 bits serial EEPROM on a 168-pin printed circuit board. The TS32MLR72V6F is a Dual In-Line Memory Module and is intended for mounting into 168-pin edge connector A sockets.
PAGE 2
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F Pin Identification Dimensions Side Millimeters Symbol Inches A 133.35±0.40 5.250±0.016 B 65.67 2.585 C 23.49 0.925 D 8.89 0.350 E 15.80 F Function SA0~SA11 Address Input SBA0, SBA1 Select Bank Address SD0~SD63 Data Input / Output. 0.622 SCB0~SCB7 Check bit (data-in / data-out) 19.80 0.780 SCK0~SCK3 Clock Input. G 29.21±0.20 1.150±0.008 H 1.27±0.10 0.050±0.004 SCKE0 Clock Enable Input.
PAGE 3
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F Pinouts: Pin Pin Pin Pin No Name No Name 01 Vss 43 Vss 02 SD0 44 NC 03 SD1 45 /SCS2 04 SD2 46 SDQM2 05 SD3 47 SDQM3 06 Vcc 48 NC 07 SD4 49 Vcc 08 SD5 50 NC 09 SD6 51 NC 10 SD7 52 *SCB2 11 SD8 53 *SCB3 12 Vss 54 Vss 13 SD9 55 SD16 14 SD10 56 SD17 15 SD11 57 SD18 16 SD12 58 SD19 17 SD13 59 Vcc 18 Vcc 60 SD20 19 SD14 61 NC 20 SD15 62 *Vref 21 *SCB0 63 *SCKE1 22 *SCB1 64 Vss 23 Vss 65 SD21 24 NC 66 SD22 25 NC 67 SD23 26 Vcc 68 Vss 27 /SWE 69 SD24 2
PAGE 4
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F Block Diagram SCB0~SCB7 RDQM5 /RCS0 PCK2 /RCS0 /RCS2 /RCS2 PCK3 PCK3 /RCS0 /RCS2 CLK /RCS0 PCK2 PCK1 PCK1 PCK2 PCK3 PCK4 PLL CLK SCLK0 /CS CLK DQM DQ0~DQ7 A0~A11,BA0,BA1 /RAS 32Mx8 SDRAM /CAS /WE CKE RDQM1 RDQM4 EEPROM RDQM7 /RCS2 /CS CLK DQM DQ0~DQ7 A0~A11,BA0,BA1 /RAS 32Mx8 SDRAM /CAS /WE CKE PCK3 DQ0~DQ7 A0~A11,BA0,BA1 /RAS 32Mx8 SDRAM /CAS /WE CKE DQM CLK RDQM6 /CS RDQM3 PCK2 DQ0~DQ7 A0~A11,BA0,BA1 /RAS 3
PAGE 5
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F ABSOLUTE MAXIMUM RATINGS Parameter Voltage on any pin relative to Vss Voltage on VDD supply to Vss Storage temperature Power dissipation Short circuit current Mean time between failure Temperature Humidity Burning Temperature Cycling Test Symbol VIN, VOUT VDD, VDDQ TSTG PD IOS MTBF THB TC Value -1.0~4.6 -1.0~4.
PAGE 6
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F CAPACITANCE (VDD = 3.
PAGE 7
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F AC OPERATING TEST CONDITIONS (VDD = 3.3V±0.3V, TA = 0 to 70°C) Parameter AC Input levels (VIH/VIL) Input timing measurement reference level Input rise and fall time Output timing measurement reference level Output load condition Value 2.4/0.4 1.4 tr/tf=1/1 1.4 See Fig. 2 Vtt=1.4V 3.3V 50 Ohm 1200 Ohm Output VOH (DC)=2.4V, IOH=-2mA VOL (DC)=0.4V, I OL=2mA Output Z0=50 Ohm 50pF 50pF 870 Ohm Unit V V ns V (Fig.
PAGE 8
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F AC CHARACTERISTICS (AC operating conditions unless otherwise noted) Refer to the individual component, not the whole module. Parameter Symbol Unit Note ns 1 ns 1, 2 ns 1, 2 ns ns ns ns ns 3 3 3 3 2 tSHZ CLK to output ns CAS latency=3 5.4 in Hi-Z Note: 1. Parameters depend on programmed CAS latency. 2. If clock rising time is longer than 1ns, (tr/2-0.5)ns should be added to the paremeter. 3.
PAGE 9
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F SIMPLIFIED TRUTH TABLE COMMAND Register SCKEn-1 SCKEn /SCS /SRAS /SCAS /SWE SDQM SBA0,1 SA10/AP Mode Register Set Auto Refresh Entry Refresh Self Refresh Exit Bank Active & Row Addr.
PAGE 10
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F Serial Presence Detect Specification Byte No. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36-61 62 Serial Presence Detect Function Described Standard Specification # of Bytes Written into Serial Memory 128bytes Total # of Bytes of S.P.
PAGE 11
168PIN PC133 Registered DIMM 256MB With 32Mx8 CL3 TS32MLR72V6F 63 64-71 72 Checksum for Bytes 0-62 Manufacturers JEDEC ID Code per JEP-108E Manufacturing Location 73-90 Manufacturers Part Number 91-92 93-94 95-98 99-125 126 127 128~ Revision Code Manufacturing Date上午 09:36 Assembly Serial Number Manufacturer Specific Data Intel Specification Frequency Intel Specification CAS# Latency/Clock Signal Support Unused Storage Locations Transcend Information Inc.