Installation Instructions

Tag Installation and Removal Procedures

The JED tag is designed for mounting to a vehicle’s interior windshield surface. It may be equipped with

3M™ Dual Lock™, hook-and-loop, or suction cups.

Required Supplies

• JED

• Commercial glass cleaner and paper towels

Installing the Tag

Choose the location for your tag (Figure 1). The tag should be mounted approximately 1 inch (2.54 cm)

below the rear view mirror post.

Clean and dry the interior windshield surface completely before mounting the tag. The windshield

temperature must be at least 68ºF (20ºC) for optimum bonding.

Dual lock or hook-and-loop mounting strips

1. Peel the backing from the mounting strips to expose adhesive (Figure 2). Leave both sides of the strips

pressed together to ensure the strips will align between the tag and the windshield. Apply the tag to

the windshield using moderate pressure.

Figure 1 Optimum Locations for Tag Performance

TA0445

Figure 2 Peel backing from mounting strips to expose adhesive